Brahler DIGIMIC DLine32 Slim UTM User manual

Quick Guide
DIGIMIC DLine32 Slim UTM
Under-table solution for audio line-in interface
Article no.: 5. 67 / 5. 68

DIGIMIC DLine32 Slim UTM Quick Guide
Quick GuideQuick Guide
Quick Guide
2
BRÄHLER Systems GmbH
Auf der Alten Burg 6
53639 Königswinter
Germany
T
+4
9 ( )
224
4
93
-
F +49 ( )2244 93 -45 [e-mail]
www.braehler-systems.com
5. 67 2 113 V1. BRÄHLER Systems is committed to continually improving its products and so reserves the right to make technical modifications without notice.
Introduction and Connectors
Introduction and ConnectorsIntroduction and Connectors
Introduction and Connectors
The DLine32 Slim UTM is a high-quality audio input device that allows you to feed an external audio source into
the DIGIMIC system. The audio source is controlled by software. What makes the DLine32 Slim UTM so
special is that it can be mounted in the smallest of spaces. The DLine32 Slim UTM can be mounted under a
table or a lectern - only what is really needed is visible: the microphone.
The DLine32 Slim UTM is available both in a version for microphone level signals (art. no. 5. 68) and in a
version for line level signals (art. no. 5. 67).
The DLine32 Slim UTM is not allowed to be connected in a chain with the DDol unit.
PREV: Connection from previous
unit
or
control panel (RJ45 connector)
NEXT: Connection to the next unit
(RJ45 plug)
XLR connector for microphone
Example system image

DIGIMIC DLine32 Slim UTM Quick Guide
Quick GuideQuick Guide
Quick Guide
3
BRÄHLER Systems GmbH
Auf der Alten Burg 6
53639 Königswinter
Germany
T
+4
9 ( )
224
4
93
-
F +49 ( )2244 93 -45 [e-mail]
www.braehler-systems.com
5. 67 2 113 V1. BRÄHLER Systems is committed to continually improving its products and so reserves the right to make technical modifications without notice.
Operation
The DLine32 Slim UTM is designed for installation in the smallest of places - for example under a table or on
the underside of a lectern. Please refer to the following drawings for the required space. (Please note that in
addition to the DLine32 Slim UTM you will also need space for plugs and cables).
Attach the DLine32 Slim UTM to its destination (drill holes specified, see pictures above). If necessary, drill
holes in the destination of your microphone (e.g. for microphones in the lectern). If necessary, fasten the
corresponding microphone jack in the drill holes (for drill sizes, please refer to the corresponding module).
Connect the DLine32 Slim UTM with its central unit DCen32 or a previous unit (PREV, RJ45 plug) and the
following units (NEXT, RJ45 plug).
Connection from the
central unit or from the
previous unit
Connection to the
next unit

DIGIMIC DLine32 Slim UTM Quick Guide
Quick GuideQuick Guide
Quick Guide
4
BRÄHLER Systems GmbH
Auf der Alten Burg 6
53639 Königswinter
Germany
T
+4
9 ( )
224
4
93
-
F +49 ( )2244 93 -45 [e-mail]
www.braehler-systems.com
5. 67 2 113 V1. BRÄHLER Systems is committed to continually improving its products and so reserves the right to make technical modifications without notice.
Connect the desired audio input device (e.g. wireless microphone, microphone in the lectern, etc.) via the XLR
connector. The devices are immediately ready for use in the system via the DIGIMIC DLine32 Slim UTM and
can be controlled via the control software MicControl or brählerOS.
The input sensitivity of the line level version is preset to approx. 7 mV. It can be adjusted internally between
1 mV and 1,2V. This adjustment should only be carried out by experienced specialists.
Connector assignment
The DLine32 Slim UTM has the following connector assignment as standard:
XLR 3
XLR 3XLR 3
XLR 3-
--
-pol.
pol. pol.
pol.
1Cable Shield
2Positive polarity (+)
3Negative polarity (-)
Warnings
The connectors of the DIGIMIC DLine32 Slim UTM are only suitable for devices of the DIGIMIC
family. Do not connect any other devices!
In case of faults, contact a technician, do not attempt to repair, unscrew or similar the DLine32
Slim UTM yourself

DIGIMIC DLine32 Slim UTM Quick Guide
Quick GuideQuick Guide
Quick Guide
5
BRÄHLER Systems GmbH
Auf der Alten Burg 6
53639 Königswinter
Germany
T
+4
9 ( )
224
4
93
-
F +49 ( )2244 93 -45 [e-mail]
www.braehler-systems.com
5. 67 2 113 V1. BRÄHLER Systems is committed to continually improving its products and so reserves the right to make technical modifications without notice.
Further information about our products can be found on the Internet under:
www.braehler-systems.com
© 2 19
Copyright by BRÄHLER Systems GmbH, Königswinter
All rights reserved, in particular (also in extracts) those of translation, reprinting, reproduction by copying or
similar procedures.
BRÄHLER Systems reserves the right to make technical changes without prior notice.
Brähler Systems GmbH
Auf der Alten Burg 6
53639 Königswinter, Germany
T [phone] -
F [phone]
[e-mail]