Bravo 254150 User manual

9/14
Instructions Continued On Back Side
Product Parts
1 - Left Frame Assembly
2 - Right Frame Assembly
3 - Top Horizontal Pole
4 - Bottom Horizontal Pole
5 - Graphic
6 - Carrying Case
Bravo Kit Item #: 254150, 254151
Graphic Item #: 254154, 254155
Display Set-Up
Step 1
Remove the parts from the
bag and place on a clean, flat
surface, along with your banner.
Lay the Left Frame Assembly (1)
on its side and unfold. First, open
the levers on each of the two
poles. Push the poles down into
the joints as shown. Repeat step
for Right Frame Assembly (2).
Step 2
Stand the Left Frame Assembly
(1) upright and fold open and
push the Vertical poles down into
the joints as shown. Repeat step
for Right Frame Assembly (2).
Step 4
Slide the Graphic (5)
on the Top and Bottom
Horizontal Poles (3 &
4) as shown. Continue
to slide the graphic until
the Horizontal Poles are
exposed on the opposite
end.
Step 3
Insert Top Horizontal Pole (3) into the Left Frame Assembly (1)
by matching up the labels on the hardware. Push in the push-
button and insert as shown. Repeat step for Bottom Pole (4).
Step 5
Connect the Right Frame Assembly (2) to the Top
Horizontal Pole (3) as shown. Repeat step for Bottom
Horizontal Pole (4).
Step 6
To adjust the
height, open the
telescoping clamp
as shown.
1
3
5
2
4
6
PUSH
IN PIN
OPEN
LEVERS

9/14
Warranty Information: All products are designed to provide the user with a cost-effective and durable product. Standard warranty is a ‘one year parts and labor’ warranty which
warrants product against defects in material and workmanship. It does not cover damage due to accidents, abuse, or normal wear and tear. Products found to be defective will
be replaced or repaired at factory’s discretion.
Step 7
Center the Graphic on the unit and with two people,
begin to raise the top vertical poles upward until the
graphic is taught to the frame
as shown.
* Verticle poles are not meant to exceed product
height of 94.125”
Step 8
Snap the telescoping clamps closed to secure poles.
To Adjust the Width
To adjust the width, locate the Blue “A“ and “B“ Labels on the
Left Frame Assembly (1). Push in the push-button and slide pole
to desired setting.
“A“ - Setting for the 10’ Bravo Graphic
(Do Not exceed 10’ width setting)
“B“ - Setting for the 8’ Bravo Graphic
(Frame will go narrower than this setting
without the use of the push-button)
Display Set-Up Continued...
Storage & Care
Place all product parts into Carry Case (6) and store in a cool dry location.
Machine wash cold, gentle cycle. Air Dry Only. DO NOT Dry Clean!