Bretford UNI1 User manual

Ref Qty Part# Description
AA 4 015-0045 FloorGlides
BB 16 030-0325 1/4-20 x 1/2” Truss Screws
CC 12 030-0207 1/4-20FlangedHexNuts
DD 4 030-0313-901 MachineRestCups
EE 4 030-0272 1/4-20x 1/2” Carriage Bolts
FF 4 030-0274 Lock Washers
GG 4 030-0006 1/4-20WingNuts
1 018-0034 13”GroundWire
HARDWARE LIST
STEP 1
AA
Twiston the floor glides(AA) onto
the bottom of both pedestals. Lay one pedestal on a flat surface with holes facing upward. Positionmodesty panel on pedestalpanel and
attach with screws (BB). Position other pedestal on
modesty panel and attach with screws. Stand unit upright.
STEP 2
BB
PARTS LIST
Qty Part# Description
2 010-1627 MachineRests
4 010-1629 Extender Brackets
1 010-1630 ModestyPanel
1 014-0166 Wire Basket
1 022-1324 Right Pedestal Assembly
1 022-1325 Left Pedestal Assembly
TOOLS REQUIRED
PhillipsScrewdriver
AdjustableWrench
Assembly Instructions
PRINTER STAND
UNI1

STEP 3
STEP 5 STEP 6
Hook wire basket into the slots
on the back of the unit.
NOTE: Includedinyourhardware
pack is ground wire. Consult your
printermanualforproperprocedures.
STEP 4
If printer is larger than printer stand, use the
extenderbracketsto give you additionallength.
Place extender brackets on machine rests and
fasten with screws (BB) and flange nuts (CC) as
shown. Slide extender brackets out to desired size.
Attach machine rests between pedestals
using screws (BB) and flange nuts (CC) as
shown. The spacing of the machine rests is
determinedby your printer size.
CC
Part# 031-0661-C
Rev. 09.24.97
DD EE FF GG
Fasten machine rest cups (DD) onto machine rests OR
extenderbrackets (if used)using carriage bolts(EE),
washer(FF) and wing nut(GG) as shown. The locationof
machine rest cups is determined by the printer size.
Onceeverything is attached, placeyour printer onstand.
Bretford Bretford Ltd.
11000 Seymour Avenue Technology House
Franklin Park, IL 60131 7 Lake End Court, Taplow
TEL: [phone] Bucks SL6 0JQ England
800.521.9614 TEL: [phone]
FAX: [phone] FAX: [phone]
800.343.1779 www.bretford.com