brewer 101381 User manual

101381 H-Cable Replacement
For Brewer Assist High-Low Table
Document #101382 Rev A
7.8.1
Description Qty
H-Cable 1
Cable Ties 8

101381 H-Cable Replacement
For Brewer Assist High-Low Table
Document #101382 Rev A7.8.2
Tools Required:
1/8” Allen Wrench
3/8” Nut Driver or Socket & Ratchet
5/16” Nut Driver or Socket & Ratchet
1/8” Flat Blade Screwdriver
3/8” Flat Blade Screwdriver
#1 Philips Screwdriver
Wire Cutters or Side Cutters
Pliers
Long Needle Nose Pliers
Adjustable Wrench
Plug unit into electrical outlet and turn power on1.
Raise seat to the full up position. Note: If the seat lift is nonfunctional2.
the seat may be raised using a lifting device designed for this purpose (the
seat section is 100 lbs). Be sure to utilize nonmarring straps, slings, or other
devices to prevent damage to the unit when lifting. Swing grab bars out of
the way to prevent damage by lifting device.
Box Shroud Removal:
Before proceeding with the next step,
turn power off at on/off switch at back of
rear cabinet and disconnect plug from the
electrical outlet!
WARNING
Support seat with a device rated for this purpose placed3.
beneath it. Seat section is 100 lbs.
Remove the (2) box shroud bolts4.
Support
Device
Box Shroud
Box Shroud
Bolts

101381 H-Cable Replacement
For Brewer Assist High-Low Table
Document #101382 Rev A
7.8.3
Remove box shroud5.
This Area
Left Blank

101381 H-Cable Replacement
For Brewer Assist High-Low Table
Document #101382 Rev A7.8.4
Push both side drawers through to provide access to1.
cable rail.
H-Cable Removal and Replacement:
Disconnect power cord from electrical plate2.
Disconnect foot control cord from electrical plate. (turn3.
locking ring counterclockwise until loose and pull connector
straight out)
Remove the four electrical plate corner screws.4.
Cable Rail
Remove the two outlet box screws.5.

101381 H-Cable Replacement
For Brewer Assist High-Low Table
Document #101382 Rev A
7.8.5
Cut and remove the (6) six cable ties along the cable6.
rail. Use caution to not cut into cables or wires.
Pull electrical plate out enough to access backside. Cut7.
cable tie at outlet box opening. Use caution to not cut into
cables or wires.
Loosen H-Cable connector nut and unscrew completely8.
from connector nut.
Pull H-Cable connector forward through hole.9.