1
Installation
Instructions
Bumper Kit
Mfg. No. 1694923
Kit Installation
HOOD REMOVAL
1. Open the hood.
2. Remove the socket and bulbs (A, Figure 2) by twist-
ing the socket counterclockwise and pulling it out of
the bezel (B). Repeat on other side.
3. Rock the hood back slightly and lift hood and grill
assembly (B, Figure 3) off pivot posts (C). Set hood
on clean 4 x 4’s or workbench.
Figure 1. Contents
Kit Contents:
Ref. Part No. Qty. Description
1 1731989A 1 Bumper Assembly
2 1931277 4 Nut, Hex, Flange Lock, 5/16-18
3 1930591 4 Capscrew, Flange Lock,
5/16-18 x 3/4
This kit is to install a bumper onto a Regent / 500 /
2500 / LT-200 Series Lawn Tractor.
1
Before beginning any service work turn off the
PTO, set the parking brake, turn off the ignition,
and disconnect the spark plug wire(s).
WARNING
2
3
23
Figure 3. Hood Removal and Installation
A. Hinge Post
B. Hood and Grill Assembly
C. Pivot Post
D. Stop
AC
B
D
Figure 2. Head Light
A. Socket and Bulbs
B. Bezel
A
B
A
