Brightz Hoop Brightz User manual

Hoop Brightz™
Instructions
© Copyright Brightz, Ltd. 2018
Patent Pending • All rights reserved
Adult installation required.
A ladder is frequently required for Hoop Brightz installation: review and follow all safety instructions
provided by ladder manufacturer. Failure to follow ladder manufacturer’s instructions can lead to
injury.
Step 1 – Install Batteries
Open latches on the side of the battery pack to access batteries. Install 3 fresh AA batteries,
observing correct polarity (+/-). Close the battery pack, making sure the latches snap shut.
Do not mix old and new batteries and do not mix alkaline, standard (carbon-zinc) or rechargeable
(nicad, ni-mh, etc.) batteries.
Caution: Batteries may explode or leak, and cause burn injury if recharged, disposed of in fire,
mixed with a different battery type, or inserted backwards. Replace all used batteries at the same
time. Clean battery contacts and contacts on the device prior to installing. Remove batteries if item
will not be used for long periods of time. When battery expires remove promptly.
Step 2 – Install Rim String Light Around Basketball Rim
Weave Rim light string (smaller of 2 strings) in net holder hooks. For basketball hoops where
weaving technique does not work, use mounting ties.
Important: Make sure end of light string with battery wire ends up close to backboard.
Latches

Step 3 –Install Backboard String Light
NOTE: Clean surface area before placing
the fasteners. Place adhesive-backed
fasteners on sides of backboard, spacing
approximately 4 fasteners to each side.
Press firmly.
Install
backboard string light
by “outlining”
backboard with light string (longer of 2 strings).
Secure with mounting ties at each fastener.
Important: Ensure final position of battery wire
is close to basketball pole.
Step 4 – Mount Battery Wires to Basketball
Pole
•Determine routing of wires from backboard and rim to
battery pack.
•Make sure to clean the area first where the fasteners will
be placed. Firmly press adhesive-backed fasteners to
basketball pole.
•Insert mounting ties in fastener openings.
•Gather battery cords, loop with mounting ties, tighten
mounting ties.
Step 5 – Install Battery Pack
Recommended location: on the back or side of the pole.
Take the silicon strap and loop one of the end holes over the T-hook on the side of the battery pack.
Place the battery pack against the hoop pole, pull the silicon strap around the pole, and secure it on
the other T-hook.
Brightz, Ltd.
8000 Yankee Road, Suite 225, Ottawa Lake, MI 49267
Email: [e-mail]
Visit us at www.brightz-ltd.com for more fun products!