Hang one or two straps
over the dryer.
If you are using one strap
keep it in the middle of the
machine. If you are using
two straps, spread them
evenly.
Make sure the buckle
hangs about 20cm down
from the top of the
machine.
See the illustration for
guidance.
Bring the straps to the
other side of the stand
and feed it through up
through the gap in the
stand similar to the
rst side.
This time make sure to
feed it up from the bottom
of the stand and have it
come out on top.
If you had the strap on the
outside of the stand on the
rst side. repeat the same
on this side.
Once the strap is through
the buckle pull down rmly
on the strap until it is
tensioned.
You do not need to keep
holding the toggle to do
this.
Finally secure the end of
the strap down with the
velcro provided.
Support:
For any enquiries regarding this product, please contact us as [email protected]
On the buckle, push
the toggle down and
towards the attached
strap.
This will open the slot
for you to slide the
other end of the strap
in.
Slide the strap in from
the Flat side of the
buckle.
Feed the strap end without
the buckle into the gap in the
dryer stand between the
platform where the machine
sits and the side frames.
If the machine is wider than
the stand you can instead
have the strap go on the
outisde of the frame.
If the Dryer stand is in it’s
smaller conguration you can
also have the strap on the
outside OR you can loosen
the two top bolts slightly to
make it easier to feed the
strap through the gap.
