Britton Hoxton HOX.007CP User manual

INSTALLATION
INSTRUCTIONS
Important
A
1 - 2
● We recommend that this product is installed by a qualified professional contractor. Such as a plumber who is certified by NVQ
(National Vocational Qualification) or SNVQ (Scottish National Vocational Qualification) Level 3.
● Please check this product immediately to ensure that it has not been damaged and is complete. Before installation, please make
sure this product is the correct model and you have all the parts required for installation and using.
● Please read these instructions carefully and keep it for future reference.
Hoxton Deck Mounted Valves Chrome/
Matt Black/ Brushed Brass
HOX.007CP/ HOX.007MB/ HOX.007BB
Maintenance
We do NOT recommend you use any household cleaners to clean the product because these cleaners change substance or formula
too frequently. The product should be always cleaned only with soapy water and rinsed with clean water and dried with a soft cloth.
Dimension
71mm
63mm
7mm
5mm
50mm
36mm
52mm

Installation (needs to be used with HOX.350DC)
Figure 1 Figure 2
NOTE: 1. Remember to turn off the mains water supply before replacing HOX.007.
2. Make sure that the handle is in closed status before installation.
1. Remove the original deck mounted handle (as boxed in Figure 1) and replace with HOX.007.
2. Please refer to Figure 2, place the rubber washer into the base, and tighten the base with the valve body.
4. Lock the handle to the base. For installation of the valve bodies, please refer to instruction included with HOX.350DC.
HANDLE
(HOT)
RUBBER
WASHER
RUBBER
WASHER
PLASTIC
WASHER
HANDLE
(COLD)
VALVE BODY
HANDLE
(HOT)
SCREW
SLEEVE
BASE
RUBBER
WASHER
HANDLE
(COLD)
HOX.007
RUBBER
WASHER
PLASTIC
WASHER
VALVE BODY
3. Fit the sleeve into the cartridge of the valve body and tighten it with screws.
2- 2 A