Broadview OfficeSuite Simplicity User manual

SETTING UP YOUR NEW OFFICESUITE SIMPLICITY™
PHONE AND BASE STATION
Or call: 1-800-221-4625
For support: www.broadviewnet.com/support

It is important that you perform these steps in this order.
Use the included Ethernet cable
(or equivalent) to connect the
base station to your Internet
router or to your local area
network for Internet access.
Use the included power adaptor
with the larger barrel connector
to connect the base station to a
wall outlet.
Connect the power adaptor with the
smaller barrel connector to the phone
charging cradle and then to a wall
outlet no more than 150 feet from the
base station. Place the phone into the
cradle to charge. The initial, full charge
may take up to 6 hours.
Insert the included batteries into the
phone and slide the battery cover into
place. Should you need to replace the
batteries, use only NiMH rechargeable
batteries. Optionally, attach the belt clip
to the phone.
1
2
3
4
Instructions:
2
1
Local Area Network or
Internet Router
Wall Outlet
Base Station

Refer to the Quick Start Guide for
information about how to use your new
OceSuite® phone.
6
Momentarily disconnect power from the base
station (leave the Ethernet cable connected)
and then reapply power.
The base station will automatically download
and install new software. The process takes 3
to 4 minutes and it is important that you do
NOT remove power again while software is
updated. Wait until the base LED is steady
amber (not blinking) for two minutes before
making calls.
5
3
4
Setting Up Voicemail
To set up your voicemail, press the voicemail
key on your phone and follow the prompts.
The initial voicemail passcode is 1234.
Phone
Phone Charging
Cradle
Wall Outlet
To make an external call, simply
dial the phone number and press
the phone key.
To make an internal call, just dial
the extension of the phone you
would like to call (103) and press
the phone key.

Or call: 1-800-221-4625
For support: www.broadviewnet.com/support