Brodit ProClip 854960 User manual

29 January, 2015, www.brodit.com, © 2015 Brodit AB
Product 854960
854960 ProClip
Center mount
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320288549606
Item no 854960 fits:
Lexus IS Series 14-15 (For all countries)
1(2)

1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read the instructions and look at the pictures before attaching the ProClip. This ProClip can be placed on
the right air vent as well.
1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Peel off the adhesive tape
cover on the ProClip. Press the thin end of the enclosed gap opener into the gap between the center console
instrument panel and the frame surrounding the panel, to widen the gap. Then press/hook the angled edge on
the lower part of the ProClip into the gap next to the gap opener. Pull out the gap opener.
2. Flip/rotate the ProClip upward, towards the upper part of the air vent.
3. Press the thin end of the gap opener into the gap between the air vent frame and the padded part of the
dashboard above the vent, to widen the gap. Flex the ProClip upward and hook the angled edge on the upper
part of the ProClip over the air vent and into the gap, next to the gap opener. Pull out the gap opener.
4. The ProClip is in place.
2(2)