Brookstone 327024 User manual

327024_Extra Battery
Size: 50mm W x 74 mm L_Output at 100%_Prints 1/1 Black
This battery is intended for use with the
FlightForce™ Battling Drones.
LI-PO Battery Warning
This battery must be recycled or disposed
of properly. Contact your local waste
management office for information on battery
recycling or disposal.
Use only the cable supplied with the drones to
recharge the battery. Improper charging may
damage the battery and the device.
Do not attempt to open the rechargeable
battery or battery pack. There are no
serviceable parts inside.
Keep the battery out of reach of children. If
swallowed, consult a physician immediately.
Do not dispose of battery in a fire as it may
explode. The battery may also explode if
damaged.
Do not use the battery if it has been damaged,
or if it is swollen, leaking, or producing an
odor. Avoid direct contact with the electrolytic
material in the battery. BC

CHARGING THE BATTERY
Charge the battery before first use. To charge
the battery:
1. Slide the Battery Brick into the
charging unit supplied with the
drones. Ensure that the connector
is inserted properly, with the
electronic connections matched.
2. Connect the USB connector to the USB
port of an active device, such as a computer
or USB power adapter (not included). While
charging, the red LED in the charging
unit will be on and the yellow LED will be
flashing. A full charge takes approximately
80 minutes.
3. When the battery is fully charged, the green
LED will be solid. Disconnect the cable,
hold the drone’s Battery Release Latch
in the unlocked position, and insert the
Battery Brick into the drone.
NOTE: Do not leave unattended while
charging. Do not charge overnight.
Brookstone.com | 1-800-846-3000
1 Innovation Way, Merrimack, NH 03054
327024
© Brookstone 2017