BSH Home Appliances Corporation
5551 McFadden Ave., Huntington Beach, CA 92649
58300000134756 ABZ EN A - 9000440467
February 2009
Assemble and Install the Mounting Kit
5By hand, bend the right and left anti-tip tabs on the
base assembly upward to a 90°angle.
6Install base assembly. With drill or Phillips screwdriver,
insert two ½” screws (circled below) into existing holes
for proper alignment. Insert four remaining ½” screws.
7 Remove all contents from inside microwave, including
glass tray and plastic guide. Lay microwave on pad or
blanket, and carefully flip the unit upside down.
8Using pliers, remove plastic feet from bottom of
microwave.
9 Insert latch in front of each base support.
10 With a flat-head screwdriver, secure base supports to
microwave using 4 self-tapping bolts. Insert bolts into
existing holes in bottom of microwave.
11 After plugging power cord back in, slide microwave
back into cabinet cutout. Be sure base supports fit
securely into rear brackets.
12 Insert Phillips-head #8-18 screw into front of each base
support (screws will thread into 90° anti-tip tabs).
13 Reattach exterior trim kit frame.
For further assistance, please contact our technical
assistance team at 1-800-444-9091.
Visit QuickFinder at http://portal.mch.bshg.com/portal
