BTC 6100 User manual

6
61 10 00 0 K KE EY YB BO OA AR RD D U US SE ER R' 'S S G GU UI ID DE E
This keyboard is fully compatible with IBM AT and PS/2.
Keyboard Cable Connector
AT Compatible Cable
(5-pin Din Connector)
Pin# Signal Name Voltage
1Keyboard Clock +5VDC Signal
2Ground 0
3Keyboard Data +5VDC Signal
4Power Supply +5VDC
5No Connection
PS/2 Compatible Cable
(6-pin Miniatures Din Connector)
Pin# Signal Name Voltage
1Keyboard Clock +5VDC Signal
2Ground 0
3Keyboard Data +5VDC Signal
4Reserved 0
5+5VDC +5VDC
6Reserved 0
The ACPI Power Management Keys and Their Functions
System requirement:
ØMicrosoftWindows98 operating system.
ØThe system supporting ACPI or APMII.
ØATX motherboard and ATX power supply.
The functions of the power management are specified and performed by Windows98 operating
system, no vendor-specified driver is needed to use them, but the Windows98 operating system is
necessary. There could be one or two or three ACPI power management keys on the keyboard, those
functions are as follows.
Power off key: Power down the system.
Sleepkey: Put the system to sleep.
Wake up key: Wake up or powers up the system.
Power key: (Single key with three functions above)
ØPress this key and hold over four seconds to power down the system.
ØPress this key and release it within four seconds to put the system to sleep.
ØWhen the system is asleep or powered down, press this key and release it within four
seconds to wake up or power up the system.

FCC GUIDELINES
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
againstharmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions may cause
harmfulinterferencetoradiocommunications.However,thereis no guarantee that interference will not
occurin aparticular installation.If thisequipment doescause harmfulinterference toradio ortelevision
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
tocorrect the interference by one or more of the following measures:
♦Reorient or relocate the receiving antenna
♦Increase the separation between the equipment and receiver
♦Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
♦Consult the dealer or an experienced radio/TV technician for help.
♦Use only shielded cables to connect I/O devices to this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference. (2) This device must accept any
interference received, including interference that may cause undesired operation.
Information to User:
FAny changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
Shielded interface cable, if any, must be used in order to comply with emission
limits.
IBM AT and PS/2 are registered trademarks of International Business Machines Corporation.
Microsoft and Windows are registered trademarks of Microsoft Corporation in the United States and/or other countries.
All other trademarks are trademarks of their respective holders.
3100504464
Version 1.0
November 1999
Printed in China