Buffalo Turbo USB Utility HD-HSU2 User manual

www.buffalotech.com
TurboUSB Utility
for DriveStation HD-HSU2 Series

The Bualo TurboUSB utility can greatly improve the data transfer rates to
and from your Bualo USB hard drive. Other USB devices are not aected
by TurboUSB software.
To install TurboUSB on your computer, insert your DriveNavigator CD in
your computer’s CD drive. Click on TurboUSB Utility.
Installation
Follow the wizard to complete the installation.

Using TurboUSB
To use TurboUSB, you must rst enable it. From the Start menu, choose
Programs > BUFFALO > TurboUSB > TurboUSB for HD-HSU2.
Click Enable and follow the directions to start TurboUSB.

Is TurboUSB enabled?
To check whether TurboUSB is enabled, right-click on My Computer and
choose Properties > Hardware > Device Manager > Universal Serial Bus
controllers. If TurboUSB is enabled, your USB storage device will have
“(TurboUSB)” added to its name.
You may also turn TurboUSB o from the same window by clicking Disable
and following the steps. You will have to unplug and reconnect the USB
hard drive to complete disabling TurboUSB. Use the ‘Safely Remove
Hardware’wizard to release the drive before unplugging it.
When the wizard instructs you to disconnect and then reconnect the USB
cable, click on the‘Safely Remove Hardware’ icon in the systray and
release the device before unplugging it.

Uninstalling
To remove the Bualo TurboUSB utility from your computer, click Start >
Programs > BUFFALO > TurboUSB > Uninstaller. This will launch an uninstall
screen. Click on Start to run the uninstallation.

Notes

v1.4
USA/Canada Technical Support is available 24 hours a day, 7 days a week
toll-free: 866-752-6210
email: [e-mail]
Europe Technical Support is available between
9am-6pm (Monday-Thursday) (GMT)
and 9am-4:30pm on Fridays.
email: [e-mail]
phone (UK only): 087 12 50 12 60*
phone: [phone]
*Calls cost 8.5p per minute
©2005-2007, Buffalo Inc.
www.buffalotech.com