Raises the rack to the highest position close
to the ceiling
Stops any movement upward or downward
Lowers the rack to its lowest position
Your BUNGY drying rack is pre-programmed with lower
and upper limit switches.
These can be changed using the provided key to turn the
2 engine tuning screws. These can be accessed after
removing the engine cover.
Bear in mind that the upper limit switch must leave a
minimum safety distance from the engine cover and the
lower limit switch must leave at least two rounds of the
suspension strips coiled on the engine.
Adjust the screw corresponding to the desired direction
- Turn to the side "-" to reduce the limit switch
- Turn to the "+" increases the limit switch
Using the wall switch
9.
10.
Technical specifications
Warranty
STOP
v. CDH1S -F01
BUNGY ensures that this equipment will remain free
from manufacturing defects for two years effective
from the date of original purchase, confirmed by proof
of purchase.
This warranty does not cover:
a. Travel and maintenance interventions
b. Transport and travel for repair at home
c. Any damage, loss, cost or expense, direct, indirect,
incidental, consequential or special, arising out of or
related to the product.
d. Damage resulting from:
• Incorrect installation
• Improper Use
• Changes to equipment
• Other causes beyond the control of BUNGY
This warranty does not affect your statutory consumer
rights, consecrated in national laws, resulting from the
respective sale / purchase contract.
Model CDH1S - E
Color White
Motor voltage 220 ~ 240VAC 50Hz
Drying rack size 1,20m x 0,70m
Clothesline linear length 8,40m
Required area for instalation 1,30m x 0,80m mínimo
Maximum height from ceiling 1,60m (lower position)
Maximum supported weight 20Kg
Reprogramming of the
limit switches
