Bunn SLCA-7 User manual

Features
Related Products
ECID# 27986
PROJECT
DAT E
01/14
Model Agency Listing
SLCA-7
Specialty Liquid
Coffee Dispenser
SLCA-7
Dimensions: 32.8” H x 19.7” W x 23.4” D
(83.3cm H x 50cm W x 59.4cm D)
EQHP-10L
Product No. : 39000.0001
Graduated Cylinder Kit
Product No.: 34843.1001
Specialty Liquid Coffee Dispenser
• Dispenses two coffees from liquid concentrate plus milk and chocolate powders
(20:1 to 50:1 products)
• Accommodates two .5 gallon (.1.9 litre) liquid coffee bibs and
two 8-pound (3.63kg) hoppers
• Bib size: 5” w x 9.25” H x 4.875” D (12.7cm W x 23.5cm H x 12.4cm D)
• Global multi-volt design is easily converted to ratings from 100 to 240 volts
(50-60 hertz) eliminating the need to inventory multiple electrical configurations
• Set up for portion-control to fill cups with a 7.25” (18.4cm) cup clearance
• Serves seven set drinks, all in a 19.7” (50cm) footprint
• Four gallon (15.14 litre) hot water tank
• Front of machine access for easy machine set up, calibration and service
• Spring loaded auger drive system for easy hopper installation
• Key lock on door prevents tampering
3/16” Replacement Tube Kit
Product No.: 39329.1000
Adapter Tube Package
Product No.: 37500.0201
8” Adjustable Legs
Product No.: 00506.0000
A6.7

BUNN®practices continuous product research and improvement. We reserve the right to change specifications and product design without notice. Such
revisions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment.
All dimensions shown in inches.
Dimensions & Specifications
Bunn-O-Matic®Corporation - 1400 Stevenson Drive Springfield, Illinois 62703 • 800-637-8606 • 217-529-6601 • Fax [phone] • www.bunn.com
Model Product Dispense Rate Volts Amps Total Capacity* Cubic Shipping Cord
Number 1.7 oz. (.05L) Watts Measure Weight Attached
Product Ratios†
SLCA-7 38900.0305 20:1 - 50:1 120 15 1800 43 cups/hr. 10.9 ft3140 lbs. Yes
208 23.7 5000 385 cups/hr. .31 M363.5 kg No
240 23.7 5800 512 cups/hr. No
†Other ratios may be available based on tube options. Please contact your BUNN Sales Representative.
*Capacity measured with a 12 oz. (.35L) cup.
Power cord (NEMA 5-15P) 15 Amp-120V machine only. (30 Amp cord and plug needed for 208V and 240V models)
Electrical: 120V requires 2-wires plus ground service rated 120V, single phase, 60 Hz.
Plumbing: 20-100 psi (138-689 kPa) from a 1/4" or larger supply line. Unit requires a 1 gpm (3.79 lpm) line flow capacity. A shut-off
valve should be installed in the line before the unit. Install a regulator in line when pressure is greater than 100 psi
(689 kPa) to reduce pressure to 50 psi (344 kPa). Supplied with 1/4" male flare fitting.
01/14 © Bunn-O-Matic Corporation