Bunn ThermoFresh Series Quick reference guide

USE & CARE INSTRUCTIONS for ThermoFresh®SERVER
with DIGITAL SIGHT GAUGE
STEP 1 STEP 2 STEP 3 STEP 4
STEP 1
Place a cup or container in
center of serving platform
as indicated.
STEP 2 STEP 3 STEP 4
39483.0006B 09/16 ©2014 Bunn-O-Matic Corporation
Open the faucet handle
until the desired quantity is
dispensed.
Flip the server cover back to
fill the Server when brewing
from a Bunn-O-Matic®Dual
TF DBC or Single TF DBC or
ICB coffee brewer.
DAILY CLEANING
Remove the lid, fill server
with cleaning solution and
thoroughly clean the inside
of server.
Runacompletebrewcycleof
just hot water into the server
and let it set for a minute.
Empty the server completely
by opening the faucet.
When proper precautions
are followed, 1.0 up to 1.5
gallons of coffee may be
brewed directly into the
server and then transported
to a remote serving location.
The server mustbeplacedon
a sturdy counter or shelf.
NOTE: Bunn-O-Matic recommends the three step method for cleaning and santizing the server. The 3 step method consists of
hot soapy water using an mild, non-citrus detergent, a fresh water rinse and an aqueous sanitizing solution using a non-chlorine
sanitizer. Do not submerge the server. Failure to follow the recommended cleaning procedures can cause corrosion to the
stainless steel surface and damage the vacuum seal. USE OF ANY CHLORINATED PRODUCT VOIDS THE FACTORY WARRANTY.
Do not submerge server.
BEVERAGE DISPENSING
Rinse server thoroughly us-
ing fresh water rinse.
Fully fill server with sanitiz-
ing solution for 5 minutes
then drain throughfullyopen
faucet.

USE & CARE INSTRUCTIONS for ThermoFresh®SERVER
with DIGITAL SIGHT GAUGE
STEP 6 STEP 7STEP 5
STEP 9
STEP 8
Remove the faucet handle/
stem assembly by unscrew-
ing the faucet nut just behind
the faucet handle.
STEP 10
Disassemble the faucet/
stem assembly. Thoroughly
wash all faucet parts, drip
tray and cover in a mild
detergent and water solu-
tion. Rinse the parts in hot
water. Sanitize the parts for
five minutes, then air dry
completely.
Wash the entire outside sur-
face of the lid assembly with
a mild detergent and water
solution and rinse with hot
water. Do not submerge.
NOTE: Thoroughly cleaning
the lid assembly fins will
prevent inaccurate level
readings.
39483.2 092116
Reassemble the faucet and
attach it to the dispenser.
When reassembling - CAU-
TION: DO NOT over-tight-
en faucet bonnet - HAND
TIGHTEN ONLY.
DAILY CLEANING (Continued)
Use cleaning brush supplied
with theserver to thoroughly
clean the fill tube of the lid
assembly and the faucet
spout.
Remove the drip tray and
drip tray cover. Thoroughly
wash in a mild detergent
and water solution. Rinse
the parts in hot water.
STEP 12STEP 11
Wash the entire outside
surface of the server with a
clean damp cloth. Do NOT
clean this equipment with a
water jet device.
Thoroughly clean all coffee
residue from the contacts
between the server lid and
the digital sight gauge. If
the sight gauge is removed
for cleaning, do not lose the
thumbscrews.