Bunn ThermoFresh SERVER Quick reference guide

USE & CARE INSTRUCTIONS for ThermoFresh®SERVER
with MECHANICAL SIGHT GAUGE
STEP 1 STEP 2 STEP 3 STEP 4
STEP 1
Place a cup or container in
center of serving platform
as indicated.
STEP 2 STEP 3 STEP 4
39483.0001B 06/11 ©2008 Bunn-O-Matic Corporation
Open the faucet handle
until the desired quantity is
dispensed.
The Server Cover needs to
be removed to fill the Server
when brewing from a Bunn-
O-Matic®Dual TF DBC or
Single TF DBC or ICB coffee
brewer.
DAILY CLEANING
Remove the lid, fill server
with cleaning solution and
thoroughly clean the inside
of server.
Runacompletebrewcycleof
just hot water into the server
and let it set for a minute.
Empty the server completely
by opening the faucet.
When proper precautions
are followed, 1.0 up to 1.5
gallons of coffee may be
brewed directly into the
server and then transported
to a remote serving location.
The server mustbe placedon
a sturdy counter or shelf.
NOTE: Bunn-O-Matic recommends the 3 step method for cleaning and sanitizing the server. The 3 step method
consists of hot soapy water using an approved detergent, a fresh water rinse, and an aqueous sanitizing solution
using an approved non-chlorine sanitizer. Do not submerge server.
BEVERAGE DISPENSING
Rinse server thoroughly us-
ing fresh water rinse.
Fully fill server with sanitiz-
ing solution for 5 minutes
then drain throughfullyopen
faucet.

USE & CARE INSTRUCTIONS for ThermoFresh®SERVER
with MECHANICAL SIGHT GAUGE
STEP 6 STEP 7STEP 5
STEP 9
STEP 8
Remove the faucet handle/
stem assembly by unscrew-
ing the faucet nut just be-
neath the faucet handle.
STEP 10 STEP 11 STEP 12
Disassemble the faucet/
stem assembly. Thoroughly
wash all faucet parts, lid,
and silicone tube in a mild
detergent and water solu-
tion. Rinse the parts in hot
water. Sanitize the parts for
five minutes, then air dry
completely.
Use enclosed cleaningbrush
to thoroughly cleanthe sight
gauge tube.
Remove sight gaugecap and
pull sight gauge tube from
the shroud.
Reassemble the faucet and
attach it, the lid, sight gauge
and silicone tube to the
dispenser.
Wash the entire outside
surface of the server with a
clean damp cloth. Do NOT
clean this equipment with a
water jet device.
DAILY CLEANING (Continued)
Remove the drip tray and
drip tray cover. Thoroughly
wash in a mild detergent
and water solution. Rinse
the parts in hot water.
Use enclosed cleaningbrush
to thoroughly clean the fau-
cet spout.
Use enclosed cleaningbrush
to thoroughly clean the fill
tube in the lid assembly.