Burlington T21A CHR User manual

Parts supplied:
Ø6.0mm
6x
H
1 - 3
Tools required:
2x
62cm Round Basin Stand
Curved Basin Stand
80cm Basin Wash Stand
T25A CHR
T49A CHR
T50 CHR
12
2x 2x
1x
1x
6x
6x
2x
4x
3
Attach the two horizontal rails to the front rail. Screw the legs into the rail.
(floor nipples)
(rubber washers)
(floor nipple washers)
Please note at this step,
if you are using the regal
designer basin stand
Extension kit (T62). Then
refer to page 3 first, and
then go onto step 4.
ST4.2 x 3.8mm
51cm Cloakroom Basin Stand
56cm / 58cm Basin Stand
61cm Basin Stand
56cm Round Basin Stand
T21A CHR
T22A CHR
T23A CHR
T24A CHR

Fix each of the two brackets onto the wall using the 4
screws provided.
Ensure that the screw heads are parallel to the floor.
Place the 4 rubber washers into the 4 recesses as shown.
H2 - 3
45
7
Check that the horizontal bracket bar is vertical
using a spirit level. Determine the final installation position and mark the 4
wall and two floor fixing hole positions in pencil.
Please make sure to include the floor nipples (and
washers if necessary) when determine the installation
position because the stand may elevate after the floor
nipples are fitted.
6
Using a 6mm drill bit drill the six holes on the
marked positions (note: In the event that the wall /
floor fixings supplied being inappropriate for the
wall / floor, please source alternatives).
Fix the floor nipples
onto the floor.
There are 6 floor nipple
washers supplied.
These can be inserted
onto the floor nipples
to adjust for an uneven
floor.
89b
For ceramic basin, place the
basin in position ensuring
that it is level.
The basin must be fixed to
the wall at the rear using
appropriate wall screws.
Fit the two legs over the floor nipples.
The 4 Rubber washers are not
recommended to use while installing
the marble basin onto the standing.
Rubber washer
For marble basin, please refer
to the BASIN INSTALLATION
INSTRUCTION.
The top part of the rail
can be adjusted slightly
if the basin is not level.
9a

Parts supplied:
H
3 - 3
Regal designer Basin Stand Extension Kit T62
2x
Please refer to the basin stand instruction for the more detail basin stand installation.
2x
Without the Extention Kit With the Extention Kit
745mm /
785mm 805mm /
845mm