Calf-Tel CT-6191 User manual

1
Hampel, W194 N11551 McCormick Drive, Germantown, WI 53022
Phone: [phone] Fax:[phone]
CT-6191
Pen Wall Attachment
Assembly Instructions
CT-6191 Pen Wall Attachment System Bill of Materials:
Item
Item Number
Description
Qty
1
CT-6191
Pen Wall Bracket
1
2
CT-HDWE-003
¼ x 2.5” Lag Screw
3
Tools Needed:
1. 5/16” Socket
Using (3) CT-HDWE-003 LAG
screws, anchor wall bracket to
wall.
Bottom of bracket is mounted
17.0” up from floor.
Panel brackets are to be
mounted on 46.25” centers.

2
Hampel, W194 N11551 McCormick Drive, Germantown, WI 53022
Phone: [phone] Fax:[phone]
Attaching the CT-6305 Upright to Door Frame
Follow the same procedure as the front
upright and align the top upright tab under
the top rear panel knuckle.
Slide the hinge rod down aligning the tabs
with the panel knuckles.

3
Hampel, W194 N11551 McCormick Drive, Germantown, WI 53022
Phone: [phone] Fax:[phone]
Attaching the CT-6315 Crossover to Uprights
Slide the top crossover section over each upright.
Using the provided screws, fasten the top crossover to
the front and back upright.
Note: The screw used for fastening the upright to the
top crossover comes pre-installed into the upright. You
will need to back the screw out using a 5/16 ratchet,
assemble the upright and crossover, and then fasten
together.

4
Hampel, W194 N11551 McCormick Drive, Germantown, WI 53022
Phone: [phone] Fax:[phone]
Attaching the CT-6310/CT-6320
Tether Assembly to Uprights
Note: The tether and mounting hardware will come
already assembled. You will need to take the nut and
washers off to assemble the eyebolt to the uprights.
Assemble the tether with the nut and washers on the
inside of both uprights as shown below.