Camec 051859 User manual

15
RV GAS HOB WITH GLASS LID
Installation, Operation and Servicing Instructions
NOTE: Please read this manual carefully before installing and
using this appliance.
Part No. 051859 Part No. 051860
This product is covered under a 12 months warranty period. Kindly
refer to the warranty policy terms and conditions available on Camec
website.
For further information or assistance, please contact our National
Customer Support Team or visit Camec website.
1. Australia on 1300 422 632 or camec.com.au
2. New Zealand on 09 257 2419 or camec.co.nz
For any retail or trade enquiries, please contact our Sales office.
CAMEC VICTORIA
47-63 Remington Drive
Dandenong South VIC 3175
23-27 Freight Drive
Somerton VIC 3062
Phone: [phone]
CAMEC NEW ZEALAND
44 Montgomerie Road
Mangere Auckland 2022
Phone: [phone]
CAMEC NEW SOUTH WALES
Units 2 & 3 No. 1 Koonya Circuit
Caringbah NSW 2229
Phone: [phone]
CAMEC QUEENSLAND
Building 3 Archerfield Industrial
Park Cnr Kerry & Beaudesert
Road Archerfield QLD 4108
Phone: [phone]
CAMEC WESTERN AUSTRALIA
190 Welshpool Road
Welshpool WA 6106
Phone: [phone]
8 Warranty

1
Table of Contents
1 General Safety Instructions……………………………..……… 2
2 Safety Warnings………………………………………….……... 3
3 Installation……………………………………….………………. 5
3.1 Installation Location……………………………………………. 7
3.2 Built-in Cut-Out Dimensions…………………..………………. 8
3.3 Gas Connection………………………………………………… 9
3.4 Electrical Connection…………………………………………... 10
4 Technical Data and Specification……………………………… 11
4.1 Control Knob and Switch………………………………………. 11
4.2 Nominal Gas Consumption…………………………………….. 11
4.3 Test Point………………………………………………………… 11
5 Operating Use…………………………………………………… 12
5.1 Electronic Ignition………………………………………..……… 12
5.2 Burner Selection……………………………………………….... 13
6 Maintenance and Cleaning…………………………………….. 13
7 Servicing…………………...…………………………………….. 14
8 Warranty …………………………………………………………. 15

2
1 General Safety Instructions
WHAT TO DO IF YOU SMELL GAS
The 2 and 3 burner gas hobs are designed in accordance to AS/NZS
5263 for the purpose of cooking food in recreational vehicles i.e.
caravans, camper trailers, motorhomes etc. Any other use shall be
considered improper.
The manufacturer does not assume any liability for damages or
injuries due to incorrect installation and/or improper use. Installation,
commissioning and service must be performed by a licensed gas
fitter, service agency, OEM or the gas supplier. Failure to do so will
void the warranty.
Evacuate all persons from the caravan or RV.
Shut off the gas supply at the gas tank or supply source.
Open all doors and windows.
DO NOT touch any electrical switch or use any phone or radio in the
vehicle.
DO NOT start the vehicle’s engine or electric generator.
DO NOT turn on the gas supply until the gas leak(s) has been repaired.
Contact the nearest gas supplier or qualified service technician for
repairs.
If you cannot reach a gas supplier or qualified service technician,
contact the nearest fire station or emergency services.

3
2 Safety Warnings
WARNING: DO NOT spray aerosols in the vicinity of this
appliance while it is in operation.
WARNING: DO NOT use or store flammable material in or
near this appliance.
WARNING: DO NOT use this appliance as a space heater.
WARNING: DO NOT place articles on or against this
appliance.
CAUTION: The glass lid is not a cooking surface. Glass lid
must be fully raised when burners are switched on.
WARNING: DO NOT modify this appliance.
WARNING: DO NOT attempt to use this appliance with or
convert to use with another type of gas. This appliance is
designed to be operated on U-LPG only.
CAUTION:
All additions or alterations to the LP Gas system
must be performed by an authorized person (consult your
LP Gas supplier).
WARNING: DO NOT operate appliance when travelling,
refueling or in a confined space.

4
WARNING: Remove all transit protection prior to usage
WARNING: DO NOT obstruct the flow of combustion and
ventilation air. All gas burning appliances consume air
(oxygen).
WARNING: DO NOT use this appliance in unventilated
structures. Make sure there is an open window or
designated ventilation opening to provide air supply.
CAUTION: Ensure valve is closed and fit gastight sealing
plug to all spare cylinders not connected, whether full or
empty.
WARNING: DO NOT check for gas leaks with an open
flame
WARNING: In the event of fire, immediately close cylinder
valve, if safe to do so.
CAUTION: Combustible gas or carbon monoxide detection
systems should be maintained to the manufacturer’s
recommendations.
WARNING: In freezing conditions the pressure of propane
gas can be reduced in the cylinder tank causing a lack of
gas pressure. This may affect the way the appliance
operates.
WARNING: This appliance is not intended for use by
persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction

5
concerning use of the appliance by a person responsible for
their safety.
WARNING: Children should not be permitted to operate this
appliance without close adult supervision.
CAUTION: Keep appliance clean and properly adjusted.
Schedule for yearly inspection and servicing by an
authorized person.
WARNING: If the appliance is to be left unused for any
length of time, it is recommended that the gas supply be
turned off at the cylinder or main supply valve feeding the
appliance.
All installations must be carried out by authorized trades persons only
in accordance with these instructions, relevant Federal and State
Regulations, and with the current requirements of AS 5601.2 “Gas
Installations”, published by Standards Australia. For information
regarding inputs and gas pressures, refer to the Data Plate attached to
the appliance.
WARNING: THIS APPLIANCE MUST BE INSTALLED
BY AUTHORISED PERSONS.
This appliance is designed to operate on Universal LPG ONLY
and corresponding supply pressure. The gas that the appliance
has been adjusted is clearly indicated on the packaging and on
the data plate attached to the back of the appliance. Check this
3 Installation

6
data before connecting the appliance to the gas cylinder. The
pressure regulator to be used between the cylinder and the
appliance must comply with the categories indicated in the table
below.
GAS kPa OUTPUT OF THE
REGULATOR
U-LPG 2.75 2.5 Kg/h
CAUTION: In order to avoid possible accidents, it is
essential for the appliance to be installed according
to the instructions contained in this manual.
WARNING: MODIFICATION OF THIS APPLIANCE
AND INCORRECT INSTALLATION IS DANGEROUS
AND WILL VOID ALL WARRANTY. DO NOT
MODIFY THIS APPLIANCE.
This appliance is not connected to a flue terminal, which
discharges the product of combustion to the outside. Any
enclosed space in which the appliance is installed must
therefore be provided with permanent ventilation in accordance
to AS 5601.2 and any regulations in force with attention being
paid to the matter of room ventilation.
CAUTION: Before installation, check that the local
distribution conditions (gas type and pressure) and the
settings of the appliance are compatible.

Min. 450mm from
top of cooking vessel
support to rangehood.
Min. 200mm
to combustible
surfaces*
Min. 200mm
to combustible
surfaces*
7
The gas connection systems and the installation rooms must be
suitable and meet safety standards.
Make sure the power is disconnected to avoid risk of installer
being electrocuted.
Make sure the appliance is installed in an environment with high
ventilation rate.
The appliance should be kept away from flammable materials.
Installation Location
This appliance is not allowed to be installed outdoors or directly
exposed to flammable materials.
The installation rooms must have a continuous air exchange to
guarantee normal and correct gas combustion.
This appliance should be built into place which is suitable for
kitchen unit.
Minimum distances to surrounding surfaces
Note:
* May be less than 200mm where
protected in accordance
with AS/NZS5601.2.
** For 3 Burner model, min. 520mm
from top of cooking vessel support
to rangehood.

8
After installation, the top of the cooking vessel support will be
located 15mm below the bench top surface.
The installer MUST test the operation of the appliance after
installation to ensure satisfactory operation.
Built-in Cut Out Dimensions
The cabinet must be mounted on a support structure, and the
material should be heat-resistant.
The cabinet built-in hole must be parallel and suitable for
installation.
The underside of this stove can become very hot during use.
When this stove is installed in a location where the underside is
easily accessible, the installation must include a barrier 30mm
below the lowest point of the stove to prevent accidental touch
access.
The data label is not usually visible after installation, so this
hotplate has been supplied with a duplicate data label. The
installer must attach the duplicate data label to an adjacent surface,
or the inside surface of a nearby cupboard, where it can be easily
referenced by the consumer after installation.
Refer to the cut-out dimensions below for the respective gas hob
model.

9
2 Burner Model
Part No. 051859
3 Burner Model
Part No. 051860
Fasten the gas hob to the cabinet with the fixing screws provided.
Gas Connection
The gas supply pipework must be installed in accordance with AS/NZS
5601.2. The gas pipework must not be subject to twisting, pulling or
other stresses. The gas supply connection point shall be accessible
with the appliance installed. Where the gas connection point is not
easily accessible for regular inspection, rigid pipe must be used.
Gas inlet connection: 5/16 SAE 45° J516 Male
X