Camp Chef SPG90B-2 User manual
STEP 1
Screw out thumb screws until flush with inside of
cooker leg. Apply extension to each leg. Hand tighten
thumb screws.
Stand cooker upright on solid level ground. To level:
loosen thumb screw on leg extension and adjust leg
height. Hand tighten thumb screw.
KEEP FOR FUTURE REFERENCE
STEP 2
Before attaching regulator to tank, ensure that all
valves are in the OFF position. Attach regulator to tank
Check all connections to ensure tightness. With all
valves in the off position, apply a soapy water solution
to all fittings, valves and connections. Turn gas on
at the tank and check for leaks at all connections.
Small bubbles will appear if connection leaks.
Tighten as needed.
REGULATOR
New Type 1 Connection: Right hand turn to connect
securely to New Type 1 tank.
TROUBLE SHOOTING
PROBLEM WITH FLAME?
(Flame should burn blue with a hint of yellow.)
Yellow Flame: Adjust air shutter open until burner
shows blue flame.
Still Yellow: Shut off valve(s) at stove and fuel tank.
Through air shutter opening, clean venturi (burner
neck) of obstructions such as cobwebs, dirt or bugs.
Open Tank Valve Slowly
Small Flame: Flame will not adjust any larger... (Safety
Feature: New Low Pressure Regulator will detect a
sudden use of gas and automatically go into a “low
flow” mode and needs to be reset) Turn off all valves
at stove and at tank. Assure all fittings are tight and
in good repair. Test for leaks. Repeat steps 2, 3 and 4.
AIR SHUTTERS
(AIR VENTS)
Low Pressure
Burner
Quemador De
Baja Presión
Faible Pression
Au Bruleur
venturi
3 Burner Range
Model: SPG90B-2
• Three Universal Output (30,000 BTU/hr)
Cast Burners
• Nickel-plated Cooking Surface
• Detachable Legs
• Convenient Cooking Height
• Appliance-style Temperature Controls
• Folding Side Shelf
US Patent Numbers: 364772
Patent Pending
THIS INSTRUCTION MANUAL CONTAINS IMPORTANT INFORMATION NECESSARY FOR THE PROPER ASSEMBLY AND SAFE USE OF THIS PRODUCT.
WARNING: Chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm are created by the combustion of propane.
Sport Utility, Big gASS Grill, Keg Roaster, Ultimate Roaster Are From the Makers of Camp Chef and Covered Under One or More of the Following Patents: 356714, 378646, 417120, 328547, 358057, 364772
KEEP FOR FUTURE REFERENCE
STEP 3
Fully open LP bottle valve. Turn valve to medium
position. Allow gas to flow to burner. Immediately turn
rotary ignitor. The ignitor should spark and light the
burner. If ignition does not occur in 5 seconds, turn the
burner control(s) off, wait 5 minutes, and repeat the
lighting procedures.
Regulator Model#
150/451, R329, RA329
RJ-A, JY70-003,
JY95A7A (JY95-007),
RYQ Series (RYQF01)
254mm (10-inch)
Maximum Pot diameter
WARNING: READ THOROUGHLY BEFORE USE
DO NOT DISCARD THESE SAFETY INSTRUCTIONS
IF YOU SMELL GAS
1. Disconnect gas to the appliance.
2. Extinguish any open flame.
3. If odor continues, immediately leave the
premises and call your gas supplier or local
fire department.
FOR OUTDOOR USE ONLY
If stored indoors, detach hoses and leave fuel
cylinder outdoors, with valve closed
and plugged.
FUEL TYPE
This unit is designed for use with propane only.
No other fuel is approved for use with this unit.
FUEL CYLINDER
Always store fuel bottles in a safe outdoor
area with valve closed and plugged. Follow the
manufacturer’s recommendation for proper use
and storage of propane cylinders. Do Not Place
Propane Cylinders Directly Under Any Part of
the Burners.
CAUTION
Place the tank so as to minimize the possibility
of someone tripping over the connection hoses
while the cooker is set up. Never Lean Over or
Stand too Near the Cooker, or Allow Children or
Pets Near the Cooker During Use.
COMBUSTIBLE MATERIALS
During operation of cooker, insure proper
clearance from any combustible materials, in
relation to the top, sides and back of cooking
appliance. For outside use only. Do not use near
flammable walls or under eaves or overhangs
of homes or garages. Never leave unattended
while hot or in use. Allow cooker to cool before
take down and storage. The propane tank must
always be stored outdoors in a well ventilated
space. NEVER STAND OR LEAN OVER COOKER
BURNER WHILE LIGHTING.
FOR YOUR SAFETY
Follow all safety, set-up, lighting and cooking
instructions. Do not store or use gasoline or
other flammable vapors and liquids in the
vicinity of this or any other appliance.
The manufacturer warrants stove components
(except paint and finish) to be free from defect
in materials and workmanship for 1 year
from the date of purchase. All accessories
(included with stove or purchased separately)
are warranted from defect in materials and
workmanship for 90 days from the original
purchasing date. Within these periods, the
manufacturer will replace or repair defective
parts deemed unusable from its original intent
by making available the parts thereof FOB Hyde
Park, UT 84318.
Product paint and finish is not warranted. The
exterior finish of the product will wear down
over time. Touch up the exterior with black,
high temperature spray paint as needed. Do
not paint the inside surfaces.
Clean the unit after each use to maintain the
finish and prolong the life of your product.
Wipe away all grease and ashes. Keep metal
products free of moisture, salts, acids and harsh
fluctuations in temperatures.
Warranty does not cover normal wear of
parts or damage caused by misuse, abuse,
verheating and alteration. Repairs or alterations
made by anyone other than Camp Chef are not
covered in this Warranty. Manufacturer will not
be held liable for any losses due to neglectful
operation. Furthermore, this Warranty does
not cover damaged caused by natural disasters
such as earthquakes, hurricanes, tornadoes,
floods, lightning, fires, etc.
Upon the expiration of this warranty all such
liability will terminate. No other warranties are
expressed or implied.
Keep all original sales receipts. Proof of
purchase is required to obtain Warranty
services. Prior written approval and a Return
Authorization Number must be obtained.
Returned items will be accepted for repair or
replacement only. Returns must be shipped
prepaid. Collect shipment or shipments without
a Return Authorization Number will not be
accepted.
*Warranty applies to the contiguous
US states only.
*LIMITEDWARRANTY
SPG90B PARTS LIST
1212SPG90parts
BBQ BOX (1)
BB90L
GRILL (1)
3-1095
LP BURNER (3)
3-0808 AIR VENT (3)
3-0826L
LP SPRING (3)
3-0980
VALVE (3)
3-0997
KNOB (3)
3-330093
DEFLECTOR (1)
3-0615-F
LP REGULATOR (1)
3-0835
MANIFOLD (1)
GB-3
1/4 THUMB SCREW (4)
3-330076
LEG EXTENSION (4)
3-104615
1.25" LEG PLUG (8)
3-097110
#8 SCREW (6)
3-0789-HEX
HOLD DOWN BRACKET (1)
3-1046HDB
SPG90 SHELF (1)
3-107110
#8 SHELF NUT (2)
3-330029
#8 SHELF SCREW (2)
3-330028
ELECTRODE LEFT & MIDDLE (2)
GBIGN1
ELECTRODE RIGHT (1)
GBIGN2
ROTARY COVER (1)
GB-6
3 PRONG IGNITER (1)
GB-4
ROTARY KNOB (1)
GB-5
GRATE HOOK (1)
3-YK01
THUMB SCREW (1)
3-YK02
How to Convert a Fire Pit,
Stove , &
Smoker to Natural Gas
NGKIT, which is our Natural Gas
Conversion Kit, is needed to
convert any Low Pressure Stove,
Smoke Vault, or Fire Pit.
Fire Pit Conversion to Natural Gas
Safety first! Make sure
everything is shut off and
that hose is removed
from propane tank.
Remove knob and valve
cover.
Remove valve from
burner, unscrew from
thermocouple wire, and
disconnect electrode
wire.
Once valve is
removed from fire
pit, drill the orifice
with a 1/8th drill bit.
Reassemble.
Stove Conversion to Natural Gas
Start by making
sure all is shut off
and that hose is
removed from
propane tank.
Remove knobs and
front panel. At this
point all you need
to do is remove
the manifold from
the valves..
Once valve is
removed from
burner, drill it’s
orifice with a #45
drill bit.
Reassemble.
NOTE: Only low
pressure stoves
(30,000BTU or
less) can be
converted to be
used with natural
gas.
Smoke Vault Conversion to Natural Gas
To convert the Smoke
Vault to natural gas you’ll
need the NGKIT and a #51
drill bit.
If you haven’t assembled
your smoker yet, remove
the valve from the burner
and use the specified drill
to widen the valve’s orifice.
If your smoker is
already assembled and
has been used, make
sure everything is
turned off and
disconnect the hose
from your smoker. Then
lay the smoker on it’s
back and remove the
burner. This will give
you access to the valve.
Drill valve’s orifice with
a #51 drill bit.
Check out the collection of camping we offer.
