2
IMPORTANT: Before copying always check the battery of UFR2 and original remote. Some transmitters
with low transmitting power, when you take remote duplicator and original remote closely, need long
time to duplicate. The remote duplicator has self-adapting function, which can improve sensitivity, pls
hold on the button patiently, until copy successfully.
Fixed Code Duplicate procedure
1. While pressing button 1 of UFR2, press 3 times button 2, then release both buttons. The LED emits slow
flashes, showing that UFR2 is in a duplicating mode.
2. Put the original remote control in front of UFR2. Press and hold the button of original remote you want to
copy, until LED of UFR2 emits quick flashes.
3. While LED of UFR2 is flashing, press the button of UFR2, you want to store the code. LED of UFR2 keeps
lighting then turns off.
Simple Rolling code duplicate procedure without sending the seed code (this
procedure is used when the receiver is in an automatic mode and allows direct
programming of remote controls D.T.P.)
1. While pressing button 1 of UFR2, press 3 times button 2, then release both buttons. The LED emits slow
flashes, showing that UFR2 is in duplicating mode.
2. Put the original remote control in front of UFR2. Press and hold the button of original remote you want to
copy until LED of UFR2 emits quick flashes.
3. While LED of UFR2 is flashing, press the button of UFR2, you want to store the code. LED of UFR2 keeps
lighting then turns off.
4. Proceed with UFR2 on the receiver, using the original programing procedure for adding new remotes.
5. The procedure D.T.P. (direct to program) is the following: Press and hold for more than 6 seconds the button
of UFR2 on which you have already copied. The LED will emit quick flashes then will turns off.
6. Remote controls which can be copied with this procedure are marked with the sign D.T.P. in the compatible
list, which you can find in the end of this manual.
Special Rolling code duplicate procedure with sending the seed code
1. While pressing button 1 of UFR2, press 3 times button 2, then release both buttons. The LED emits slow
flashes, showing that UFR2 is in duplicating mode.
2. Put the original remote control in front of UFR2. Press and hold the button of original remote you want to
copy until LED of UFR2 turns on. Then release the button of the original remote and wait until the LED of
UFR2 emits slow flashes.
3. Press the hide button of the original remote to send the seed code and wait until the LED of UFR2 emits quick
flashes.
4. Press the button of UFR2 you want to store the code. The LED of UFR2 will turn on, wait until the LED turns off,
thus showing that the duplicating procedure is finished.
