
ELURA20 MC A, ELURA10 A
CHAPTER 1. GENERAL DESCRIPTION OF PRODUCT
1-9
5-11 Built-in microphone Stereo microphone (electret condenser microphone used).
Stereo using on-directional microphone ×3 + electrical circuit (3-element microphone).
5-11-1 Wind cut function With on/off switch (menu selection for built-in microphone only).
5-12 Additional functions
5-12-1 Time code Recording time (0:00:00 - 7:59:59) is displayed and recorded in the sub code area.
5-12-2 Data code There is no recording time display, but the recording date/time and camera data are recorded
and can be displayed during play.
Date/time Coupling range: January 1, 2001 to December 31, 2030 (initial setting: January 1, 2001).
World time capability. Automatic setting to the date/time of travel destinations by selecting the
destination city. Daylight saving time capability. Three display modes are available for play:
date, date and time, and time (January 1, 1990 to December 31, 2089).
Camera data Values such as shutter speed and aperture value are recorded (no display during recording) and
can be displayed during play.
5-12-3 Assessory shoe None.
5-12-4 Image search function Tape can be played (forward/reverse) during camera recording pause by operating the Rec Search button.
5-12-5 Rec review function Started by operating the Rec Check button ( ) during camera recording pause.
5-12-6 Card review function Yes (MC model only) The last image recorded on the memory card is read out by operating the
REC Check button ( ) on the card recording mode. The image read out can be protected or deleted.
5-12-7 Zero set memory Yes. Tape can be forwarded or rewound continuously until the zero set memory key of the WL-
D75/WL-D76 is operated (The counter value is set to 0:00:00.) (Zero set is possible only during
recording, not during play.)
5-12-8 Remote control ON/OFF Yes. Available in both the camera recording and the VCR modes (menu selection).
5-12-9 Selftimer 10 sec. (Approximately 2 sec. when the wireless controller WL-D75/WL-D76 is used.)
5-12-10 Headphone volume adjustment Adjustment is possible using the multi-dial.
6 Recorder unit
6-1 Recording functions Camera recording, DV input recording, analog input recording.
6-1-1 Recording format Personal DVC (SD specifications).
6-1-2 Tape speed
SD specifications Approx. 18.81mm/sec. (SP mode), approx. 12.56mm/sec. (LP mode)
SDL specifikations Approx. 9.41mm/sec. (ESP mode), approx 6.28mm/sec. (ELP mode)
6-1-3 DV input recording Conforms to IEEE 1394.
Records video and audio signals from a digital video camera connected with the DV cable.
6-1-4 Analog input recording The S-video jack and AV mini-jack are used to recordanalog video and audio signals.
6-1-5
Terminal priority during recording
DV jack > S-video jack > AV mini-jack
6-2 Insert recording Yes.
6-2-1 Insertable tape Only tapes with SP recording can be inserted.
6-3 Dubbing Yes (SD specification tape only)
6-3-1 Tapes usable Only tapes with 12-bit SP recording other than for audio dubbing 4-channel simultaneous re-
cordings can be used for dubbing.
6-3-2 Dubbing signal input Line (AV mini-jack) or microphone (external/internal) audio signals.
6-3-3 Dubbing selection Operate the dubbing button of the remote control in play pause status.
6-4 Play functions Standard play and special play
6-4-1 Standard play
a. Video Video recorded in the SP, LP,
E
SP or
E
LP mode
b. Audio
16-bit Sampling frequency 48KHz, 44.1KHz, 32KHz. (except for SDL specifications)
12-bit Sampling frequency 32KHz.
Play using stereo 1, stereo 2 or a mix of stereo 1 and 2 (variable mix ratio).
6-4-2 Special play Video only play
a. Freeze frame play Movie picture : pure frame play
Progressive : frame play
b. Fast forward play Approx. 9.5×speed.
c. Rewind play Approx. 9.5×speed.
d. Frame forward play Forward/reverse
e. Slow play Forward/reverse 1/5×speed (corresponds to forward/reverse 1/10×speed)
f. 1×speed play Forward/reverse
g. 2×speed play Forward/reverse 2×speed
h. Edit search Forward/reverse