Caterlite CN861 User manual

Ice Maker
Instruction manual
Model
CN861

1
UK
Safety Tips
• Position on a flat, stable surface.
• A service agent/qualified technician should carry out installation and any repairs if required. Do not
remove any components or service panels on this product.
• Consult Local and National Standards to comply with the following:
• Health and Safety at Work Legislation
• BS EN Codes of Practice
• Fire Precautions
• IEE Wiring Regulations
• Building Regulations
• DO NOT immerse in water, or use steam/jet washers to clean the unit.
• DO NOT cover the appliance when it is operating.
• Always carry, store and handle the appliance in a vertical position.
• Replace any unused water in the tank at least once every 24 hours.
• For indoor use only.
• Keep all packaging away from children. Dispose of packaging in accordance to the regulations of local
authorities.
• If the power cord is damaged, it must be replaced by an POLAR agent or a recommended qualified
technician in order to avoid a hazard.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory,
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning the use of the appliance by a person responsible for their safety. Children
should be supervised to ensure that they do not play with the appliance.
Caution Risk of Fire
Do not store explosive substances such as aerosol cans with a flammable propellant in this
appliance
Warning: Keep clear of obstruction all ventilation openings in the appliance enclousure or in the structure
for building-in
Warning : Do not use mechanical devices or other means to accelerate the defrosting process, other than
those recommended by the manufacturer
Warning: Do not damge the refrigerant circuit
Warning: Do not use electrical applainces inside the food storage comnpartments of the applaince, unless
they are the type recommended by the manufacturer
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this machine will provide the best possible performance from your POLAR product.
Pack Contents
The following is included:
•IceMaker
• Removable ice basket
•Icescoop
• Instruction manual

2
UK
Telephone Helpline: 0845 146 2887
POLAR prides itself on quality and service, ensuring that at the time of packaging the contents are supplied
fully functional and free of damage.
Should you find any damage as a result of transit, please contact your POLAR dealer immediately.
Installation
1. Remove the appliance from the packaging and remove the protective film from all surfaces.
2. When positioning the appliance, maintain a distance of 20cm (7 inches) between the appliance and
walls or other objects for ventilation. Increase this distance if the obstacle is a heat source.
3. If necessary, adjust the screw legs of the appliance to make it level. The efficiency of the appliance
can be reduced if it is unevenly located.
Operation
Control Panel
Making Ice
Each time the appliance is refilled, the first ice making cycle is used to reduce the water temperature. This
results in uneven ice cube production which is perfectly normal. You may wish to discard ice created in the
first two production cycles.
1. Lift the access lid and fill the water tank up the level of the ice basket shelf.
2. Connect the appliance to the power and press the POWER button.
3. Press the ‘SELECT’ button repeatedly to scroll through the ice cube sizes (S=Small, L=Large). Stop
when the required size is illuminated.
Note: If the appliance has not been stored or moved in an upright position, let it stand
upright for approximately 12 hours before operation. If in doubt allow the appliance to
stand.
Note: Before using for the first time, clean the water tank, ice basket and ice basket
shelf. Use the first 3 ice making cycle to flush out the system. Discard the water and ice
created from the first 3 cycles.
Note: The ice making cycle will vary depending on the size of cube selected. Larger
cubes will take longer to produce.


3
UK
4. The appliance will run a startup routine and then begin ice production.
5. When the cubes reach the ice sensor the appliance will stop production. Production resumes once ice
has been removed.
6. Press the STOP button at any time to halt the ice making process.
Cleaning, Care & Maintenance
• Always switch off and disconnect the power supply before cleaning.
• Warm, soapy water is recommended for cleaning. Cleaning agents may leave harmful residues. DO
NOT wash the base unit, instead wipe the exterior with a damp cloth.
• A POLAR agent or qualified technician should carry out repairs if required.
• Clean the water filter regularly with a small brush, particularly in hard water areas. The water filter is
located in the pump inlet at the bottom of the water tank, remove by pulling out with fingers.
• If the appliance is to be left unused for longer than 24 hours, loosen the drain screw and drain the
water from the tank.
• The inner removable parts and water tank should be cleaned regularly.
Note: If the water level is too low, the Water Low indicator lights up and the appliance
appliance stops working. Fill the water tank and the appliance will restart automatically.

4
UK
Telephone Helpline: 0845 146 2887
Troubleshooting
Technical Specifications
Fault Probable Cause Action
The appliance is
not working
The appliance is not
switched on
Check the appliance is plugged in correctly and switched on
Plug and lead are
damaged
Call POLAR agent or qualified technician
Fuse in the plug has
blown
Replace the plug fuse
Power supply Check power supply
Internal wiring fault Call POLAR agent or qualified technician
Appliance is noisy
or works
intermittently
Power fluctuations Turn off the appliance and restart after 3 minutes
Add Water
indicator is lit
Water level is low or
tank is empty
Refill water tank and restart
Water filter is blocked Clean water filter and restart appliance
Ice Full indicator is
lit
Ice basket full Empty the ice basket
All indicators flash
together
Water box is blocked
and cannot tilt
Disconnect from the power supply. Remove some of the ice
cubes and gently tilt the water box by hand. Restart the
appliance after 3 minutes
Ice cubes are
sticking together
Ice making cycle is
too long
Reset the ice cube size and restart the appliance
Water temperature is
too low
Empty water tank and refill
Compressor runs
but no ice is made
Refrigerant leak or
block in the
refrigerant system
Call POLAR agent or qualified technician
Model Voltage Power Current
Water
Tank
Volume
Bin
Storage
Ice
Making
Capacity
Refrigerant
Dimensions
h x w x d
mm
Weight
CN861 230V
50Hz
120W 0.5A 2 litres 0.6kg 10kg/
24 hours
R600a 315 x 244 x
373
9.5 kg

5
UK
Electrical Wiring
This appliance is supplied with a 3 pin, moulded, BS1363 plug and lead, with a 3 amp fuse as standard.
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed, using a dedicated earthing circuit.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency
disconnection being required they must be readily accessible.
Disposal
EU regulations require refrigeration products to be disposed of by specialist companies who remove or
recycle all gasses, metal and plastic components.
Consult your local waste collection authority regarding disposal of your appliance. Local authorities are not
obliged to dispose of commercial refrigeration equipment but may be able to offer advice on how to dispose
of the equipment locally.
Alternatively call the POLAR helpline for details of national disposal companies within the EU
Compliance
POLAR parts have undergone strict product testing in order to comply with regulatory standards and
specifications set by international, independent, and federal authorities.
POLAR products have been approved to carry the following symbol:
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic,
mechanical, photocopying, recording or otherwise, without the prior written permission of POLAR.
Every effort is made to ensure all details are correct at the time of going to press, however, POLAR reserve the right to change
specifications without notice.

DECLARATION OF CONFORMITY
• Conformiteitsverklaring • Déclaration de conformité • Konformitätserklärung • Dichiarazione di conformità •
• Declaración de conformidad • Declaração de conformidade
I, the undersigned, hereby declare that the equipment specified above conforms to the above Directive(s) and
Standard(s). Ik, de ondergetekende, verklaar hierbij dat de hierboven gespecificeerde uitrusting goedgekeurd is
volgens de bovenstaande Richtlijn(en) en Standaard(en). Je soussigné, confirme la conformité de l'équipement cité
dans la présente à la / aux Directive(s) et Norme(s) ci-dessus. Ich, der/die Unterzeichnende, erkläre hiermit, dass das
oben angegebene Gerät der/den oben angeführten Richtlinie(n) und Norm(en) entspricht. Il sottoscritto dichiara che
l'apparecchiatura di sopra specificata è conforme alle Direttive e agli Standard sopra riportati. El abajo firmante declara
por la presente que el equipo arriba especificado está en conformidad con la(s) directiva(s) y estándar(es) arriba
mencionadas. Eu, o abaixo-assinado, declaro que o equipamento anteriormente especificado está em conformidade
com a(s) anterior(es) Directiva(s) e Norma(s)
Equipment Type • Uitrustingstype • Type d'équipement •
Gerätetyp •Tipo di apparecchiatura • Tipo de equipo • Tipo
de equipamento
Ice Maker
Model • Modèle • Modell • Modello • Modelo • Malli CN861
Application of Council Directives(s)
Toepassing van Europese Richtlijn(en) • Application de la/
des directive(s) du Conseil • Anwendbare EU-Richtlinie(n) •
Applicazione delle Direttive • Aplicación de la(s) directiva(s)
del consejo • Aplicação de directiva(s) do Conselho
Low Voltage Directive (LVD) 2014/35/EU - recast of
2006/95/EC
Electro-Magnetic Compatibility (EMC) Directive
2014/30/EU - recast of 2004/108/EC
Restriction of Hazardous Substances Directive
(RoHS) 2011/65/EU
Energy-related Products Directive (ERP) 2009/125/
EC
Standards
Standaarden • Normes • Normen • Standard • Estándares •
Normas
EN 50106:2008, EN 60335-1:2012 + AC:2014 +
A11:2014, EN 60335-2-24:2010, EN 62233:2008 +
AC:2008, EN 55014-1:2006 + A1:2009 + A2:2011
EN 55014-2:2015, EN 61000-3-2:2014
EN 61000-3-3:2013, EN 50581:2012
Commission Regulation (EC) 1275/2008 -
ecodesign requirements standby and off mode
electrical power consumption
Producer Name • Naam fabrikant • Nom du producteur •
Name des Herstellers • Nome del produttore • Nombre del
fabricante • Nome do fabricante
Caterlite
Producer Address • Adres fabrikant • Adresse du
producteur • Anschrift des Herstellers • Indirizzo del
produttore • Dirección del fabricante • Endereço do
fabricante
Fourth Way,
Avonmouth,
Bristol,BS11 8TB
United Kingdom
Date • Data • Date • Datum • Data • Fecha • Data 28/10/2016
Signature • Handtekening • Signature • Unterschrift
Firma • Firma • Assinatura
Full Name • Volledige naam • Nom et prénom • Vollständiger Name •
Nome completo • Nombre completo • Nome por extenso
Richard Cromwell
Position • Functie • Fonction • Position • Qualifica • Posición • Função Commercial Director

CN861_UK_V1