CDP Mailbox Protector User manual

All of us at Custom Design Products would like to sincerely thank you for your purchase of the Mailbox
Protector. Our goal is to create products that are designed to add value to and protect your largest
investment- your home. Our number one priority is quality and we are proud to say that our products are
100% designed and manufactured in Kalamazoo, Michigan.
We want to hear what you think of the Mailbox Protector! Your opinion is important to us as we want to
continue to improve our products and serve our customers. Please email us at
[e-mail], by phone at [phone] (M-F 8:00-4:00 EST), or by visiting our
website at www.customdesignproductsusa.com.
Sincerely,
Custom Design Products Team
What’s Required
(Not Included)
What’s Included
1 5/8” X 6’ Chain Link
Fence Post Pipe
(Preferred) OR 5’ T-
Post(2 Req.)
x1
x4
x1
x7
x2
Accessory Slot
D
C
A
B
E
We offer PROFESSIONAL INSTALLATION throughout West Michigan.
Contact us at [phone] (M-F 8:00-4:00 EST) or email us at
[e-mail] for more information. You can
also find out more at www.customdesignproductsusa.com
Post Driver
Level
Phillips
Screwdriver
(#6)
Tape Measure
www.customdesignproductsusa.com

Always follow local rules and regulations. Verify underground utilities prior to installation by calling an underground
utility locating service at 811.
Step # 1
Drive first pole/post
into the ground using
post driver. Use level
to ensure
straightness. 48”
should be left above
ground level.
Step # 2
Use panel to
establish spacing for
second pole/post.
Distance between
pole/post is 19” on
center. Drive second
pole/post to the same
depth of 48”.
A
Step # 3
Snap together (3)
pieces for each
pole/post.
Slide assemblies on
each pole/post.
Note: (1) extra
piece provided for
uneven ground.
B
B
Step # 4
Slide (4) panel
onto leg assemblies,
snapping each panel
into place by pushing
down firmly in center.
A
Step # 5
Slide panel onto
assembly with
accessory slot facing
AWAY from street.
This slot to be used
for CDP Mailbox
Protector Accessories.
If you desire, now is
the time to install the
included flag bracket.
Accessory Slot
C
Step # 6
Place on top of
assembly. Using the
two outside
counterbored holes,
fasten with
screws (2) using a #6
Phillips screw driver.
D
E
www.customdesignproductsusa.com
Note: The 2 inner
holes are to mount
the optional
(included) address
plaque.