Chad Valley 2 Ring Pool Owner's manual

Assembly Instructions
Step 1
Inflate The 2 Ring Pool
Note: If the valve cannot
be recessed into the unit,
it may be the indication of
over inflation.
Pinch valve at its base
with fingers, insert
pressure plug into
opening and pump air in.
Seal the valve with valve
lid and press the valve
into the unit to get a flat
surface. Do not over
inflate or use high
-pressure to inflate this
product.
3
Produced for Chad Vallley Toys. Country of origin: CHINA
Address: 488-499 Avebury Boulevard, Central Milton Keynes, MK9 2NW.
www.argos.co.uk/chadvalley
Not suitable for children under 3 years
due to small parts, choking hazard.
2 Ring Pool
Important – Please read these instructions fully before assembly or use
These instructions contain important information which will help you get the best from your
product and ensure safe and correct assembly, use and maintenance.
Assembly & User Instructions - Please keep for future reference 365/3007
Important
Age: 3 years +
Argos Ltd.
If you need help or have damaged or missing parts, call the Customer Helpline: 0345 640 0800.

Safety Information
Important – Please read these instructions fully before assembly or use
1. Keep the assembly and installation instructions for
further reference.
2. Keep out of baby’s reach.
3. Not suitable for children under 36 months-small parts,
choking hazard.
4. The product is not a life-saving device.
5. Do not leave child unattended while device is in use.
6. The product must be assembled/disassembled by adult.
7. Area of placement must be flat and even and free of sharp.
8. Outdoor use. Only for domestic use.
9. Do not install over concrete, asphalt or any other hard
surface.
10. Only place item on the level surface at least 2m from
any structure or obstruction such as a fence, garage,
house , overhanging branches, laundry lines or
electrical wires. Check no debris underneath that
could cause puncture.
1. To Store: Simply deflate and gentle and fold. Dry
before storing. Stored in a well-ventilated area, keep
out of direct sunlight.
2. To Clean: rinse with warm soapy water and hang to
dry. Never iron or brush. Do not clean with solvent
cleaning agents. It will damage the product permanently.
3. Do not drag while it is loaded or sharp object can
puncture.
1. Clean area for repair thoroughly.
2. Press patch firmly over puncture.
3. Do not inflate for 30 minutes.
1. Be sure this item is at room temperature before
inflating.
2. Keep away from heat, rough surfaces and all sharp
objects.
Before use
Maintenance And Care
Repair Instructions
Warning! Never leave your child unattended
– drowning hazard.
Addtional Warnings
1. Read the manual and follow the instructions relating to
safety tips, correct and completed product assembly,
setting into service, use and maintenance.
2. For your own safety, always heed the advice and
warnings in these instructions.
3. Non-compliance with these operating instructions may
expose you to serious danger. Only use the product in
the places and conditions for which it is intended.
4. Ensure that riders are properly distributed on the
products.
5. Keep away from heat, rough surfaces and all sharp
objects.
6. Long time expose product under the sun or close to
heat source may deform or damage the product.
7. When moving the inflated product, strongly recom
mend to deflate the product then do it. That can avoid
product damage. In case really need to move it without
deflation,prop up the base from bottom instead of hold
the product from horizantal body or top portion.
8. See product or packaging for additional warning.
WARNING
ATTENTION