Chamberlain LiftMaster CSW200UL Series User manual

Top View of Type 3
Side View of Type 3
Front
Front
22”
2”
19 1/
4”
Weld Completely
around posts
W4
OFF
ON
© 2004 The Chamberlain Group, Inc.
All Rights Reserved
®
™
4“ Square Posts welded on Inside
Type 3
4“ O.D. Heavy Walled
Square Posts
Not Provided
Model # MPEL
For Technical Support
and Ordering Parts:
1-800-528-2806
Top View of Typical
Standard Installation
35.5"
46"
29.5"
11"
Hinge
Center
Note: Refer to the instruction
manual for different installation
setups. Dimensions will vary.
Front
W4
OFF
ON
Front
Front
Front Front
Top View of Type 1 Top View of Type 2
Mounting Holes Mounting HolesMounting Holes
Mounting HolesMounting Holes
Conduit Holes Conduit Holes
Mounting Holes
22”
19 1/
4”
15 3/ 4” 22 1/ 4”
16 1/ 2”
16 1/ 2”
W4
OFF
ON
CSW200UL™ Series Mounting Plate
3“ Posts mounted on Outside 3“ Posts mounted on Inside
Type 1 Type 2
Cement posts in place. Depth
of posts determined by soil
conditions and local codes.
Power and control
wiring should be run
in separate conduits.
Power and control
wiring should be run
in separate conduits.
Cement posts in place. Depth
of posts determined by soil
conditions and local codes.
3“ O.D. Heavy Walled Posts and U-Bolts
Not Provided
Distance between
posts are critical!
Plate MUST be Level! Plate MUST be Level!
Top View o
f
T
y
pe 3
F
ront
M
ounting Holes
M
ountin
g
Holes
Center posts
between
mounting holes.
keep the posts
close to the
plate edge.

Front
Front
Front
3“ Posts mounted on Outside
SL3000UL™ Series Mounting Plate
3“ Posts mounted on Inside
Cement posts in place. Depth
of posts determined by soil
conditions and local codes.
Cement posts in place. Depth
of posts determined by soil
conditions and local codes.
Power and control
wiring should be run
in separate conduits.
Power and control
wiring should be run
in separate conduits.
3“ O.D. Heavy Walled Posts and U-Bolts
Not Provided
Top View of Type 1
Top View of Type 2
01-51150
Mounting Holes
Mounting Holes
Conduit Holes Conduit Holes
Mounting Holes
Mounting Holes
22”
19 1/
4”
13 3/ 4”
13 3/ 4”
18 1/ 2”
Distance between
posts are critical!
Front
25”
Type 1 Type 2
Plate MUST be Level! Plate MUST be Level!
4“ Square Posts welded on Inside
4“ O.D. Heavy Walled Square Posts
Not Provided
22”
2” 19 1/
4”
Side View of Type 3
Weld
Completely
around posts.
Center posts
between
mounting holes.
© 2004 The Chamberlain Group, Inc.
All Rights Reserved
®
™
Front
Conduit Holes
Front
4“
Minimum
Gate
Front
Type 3
Top View of Type 3
UL Rollers
Top View of Typical
Installation
For Technical Support
and Ordering Parts:
1-800-528-2806
Model # MPEL
Mounting Holes
Mounting Holes
keep the posts
close to the
plate edge.