ChapterHouse SXV-141 User manual

SUPERHEAVY ASSAULT WALKER
ASSEMBLY INSTRUCTIONS
This kit is made from resin parts, which may be coated in a wax based release
agent (used to help release the parts from the moulds during production). It is
recommended that all parts be washed prior to assembly to remove this release
agent
All parts will require cleaning up and assembly using an intermediate collection
of modelling tools, including knife, saw, files, sandpaper, epoxy putty and glue.
A two-part epoxy glue is recommended for large joints such as the hips.
WARNING: RESIN DUST CAN BE HARMFUL TO THE LUNGS - ALWAYS WEAR APPROPRIATE
PROTECTIVE EQUIPMENT WHEN WORKING WITH RESIN PARTS, AND ENSURE THAT THE DUST IS
NOT ALLOWED TO BLOW AWAY FROM THE WORK AREA. ALWAYS CLEAN UP APPROPRIATELY AFTER
WORKING WITH RESIN PARTS.
SUPERHEAVY ASSAULT WALKER CREATED BY ZAC SODEN (MANGOZAC). COPYRIGHT 2010.
PRODUCED AND DISTRIBUTED BY CHAPTERHOUSE STUDIOS
Model painted by Mark Tait

UPPER LEG
LOWER LEG
JOINT AXLE
JOINT COVER
DISC
PISTON ENDS
PISTONS
FOOT
1. Insert upper leg into lower leg
2. Push joint axle through holes
3. Glue joint cover disc over each end
of axle.
Note: pistons may require cutting to
length to suit selected pose.
1
3
2
SUPERHEAVY ASSAULT WALKER ASSEMBLY INSTRUCTIONS
Page 1 - LEG
Repeat for all four legs
SUPERHEAVY ASSAULT WALKER CREATED BY ZAC SODEN (MANGOZAC). COPYRIGHT 2010.
PRODUCED AND DISTRIBUTED BY CHAPTERHOUSE STUDIOS

RAILGUN
ROTATOR
CAPACITOR BLOCK
RAILGUN
Note: Left and right side assemblies
use same parts assembled as mirror
images.
SUPERHEAVY ASSAULT WALKER ASSEMBLY INSTRUCTIONS
Page 2 - WEAPONS
Right side assembly
Left side assembly
LASER MARKER TURRET GATTLING CANNON
SUPERHEAVY ASSAULT WALKER CREATED BY ZAC SODEN (MANGOZAC). COPYRIGHT 2010.
PRODUCED AND DISTRIBUTED BY CHAPTERHOUSE STUDIOS

Page 3 - CHASSIS
SUPERHEAVY ASSAULT WALKER ASSEMBLY INSTRUCTIONS
LEFT
RAILGUN
ASSEMBLY
RIGHT
RAILGUN
ASSEMBLY
FORWARD
CHASSIS
ROTATOR
AXLE
ROTATOR
AXLE
LEFT
ROTATOR
END
RIGHT
ROTATOR
END
REAR
CHASSIS
CHASSIS
HATCH
JOINT
COVER
DISC
JOINT
COVER
DISC
Do not glue railgun assemblies
into place. They should rotate
freely on the rotator axle and
will be held in place using
the rotator ends.
Ensure that the square peg on
the bottom of the rear chassis
is inserted into the matching
hole on the front chassis.
SUPERHEAVY ASSAULT WALKER CREATED BY ZAC SODEN (MANGOZAC). COPYRIGHT 2010.
PRODUCED AND DISTRIBUTED BY CHAPTERHOUSE STUDIOS

SUPERHEAVY ASSAULT WALKER ASSEMBLY INSTRUCTIONS Page 4 - FINAL ASSEMBLY
LEG
ASSEMBLY LEG
ASSEMBLY
PELVIS
HATCH
GATTLING
CANNON
GATTLING
CANNON
LASER
MARKER
TURRET
CHASSIS
ASSEMBLY
PELVIS
Do not glue joint between
chassis and pelvis, so that
the chassis can rotate freely
and be removed for transport.
Hip joints (between leg and
pelvis) MUST be pinned using
metal rods
SUPERHEAVY ASSAULT WALKER CREATED BY ZAC SODEN (MANGOZAC). COPYRIGHT 2010.
PRODUCED AND DISTRIBUTED BY CHAPTERHOUSE STUDIOS