
5
Safety Tips
•   Before opening LP cylinder valve, check the coupling nut 
for tightness.
•   When this appliance is not in use, turn off control knob 
and LP cylinder valve. 
•   The grease tray must be inserted into appliance and 
emptied after each use. 
•   If you notice grease or other hot material dripping from 
appliance onto valve, hose or regulator, turn off gas 
supply at once. Determine the cause, correct it, then 
clean and inspect valve, hose and regulator before 
continuing. Perform a leak test.
•   Do not store objects or materials under the appliance 
enclosure that would block the flow of combustion air to 
the underside of either the control panel or the firebox 
bowl.
•   The regulator may make a humming or whistling noise 
during operation. This will not affect safety or use of the 
appliance.
•   If you have an appliance problem see the 
"Troubleshooting Section".
•   If the regulator frosts, turn off appliance and LP cylinder 
valve immediately. This indicates a problem with the 
cylinder and it should not be used on any product. 
Return to supplier!
For Safe Use of Your appliance and to 
Avoid Serious Injury:
•  The use of alcohol, prescription or non-prescription 
drugs may impair the consumer's ability to properly 
assemble or safely operate the appliance.
•  When cooking, the appliance must be on a level, 
stable noncombustible surface in an area clear of 
combustible material. An asphalt surface (blacktop) 
may not be acceptable for this purpose. 
•  Do not leave appliance unattended. Keep children 
and pets away from the appliance at all times. 
•  Do not place empty cooking vessel on the appliance 
while in operation. Use caution when placing 
anything in cooking vessel while the appliance is in 
operation.
•  Do not move the appliance when in use. Allow the 
cooking vessel to cool to 115°F (45°C) before 
moving or storing.
•  This appliance is not intended for and should never 
be used as a heater.
•  This appliance will be hot during and after use. Use 
insulated oven mitts or gloves and long-handled 
barbecue utensils for protection from hot surfaces or 
splatter from cooking liquids. 
•  Keep appliance area clear and free from materials  
that burn.
•  Keep appliance area clear and free from combustible 
materials, gasoline and other flammable vapors and 
liquids.
•  Keep fuel supply hose away from any heated 
surfaces.
•  Use  only in well-ventilated space. NEVER appliance 
use in enclosed space such as carport, garage, 
porch, covered patio, or under an overhead structure 
of any kind.
• Use appliance at least 3 ft. from any wall or 
surface. Maintain 10 ft. clearance to objects that can 
catch fire or sources of ignition such as pilot lights on 
water heaters, live electrical appliances, etc.
WARNING
•  NEVER attempt to light burner with any type of 
closed cover . A buildup of non-ignited gas inside 
a closed appliance is hazardous.
•  Never operate appliance with LP cylinder out of  
correct position specified in assembly 
instructions. 
•  Always close LP cylinder valve and remove 
coupling nut before moving LP cylinder from 
specified operation position.
Ignitor Lighting
•    Do not lean over appliance while lighting.
1.  Turn ON LP gas cylinder.
2.  Open lid during lighting.
3.  Press and turn the control knob to     
4.  Turn ROTARY IGNITOR knob rapidly.
5.  If ignition does not occur in 5 seconds, turn the burner 
control knob       OFF, wait 5 minutes, and repeat 
lighting procedure.
If ignition still does not occur, follow match-lighting 
instructions.
CAUTION
WARNING
If ignition does NOT occur in 5 seconds, turn the 
control knob       OFF, wait 5 minutes and repeat 
the lighting procedure. If the burner does not 
ignite with the valve open, gas will continue to 
flow out of the burner and could accidently ignite 
with risk of injury.
Turn control knob and LP cylinder OFF when 
not in use.
Match-Lighting
•  Do not lean over appliance while lighting.
1.  Turn ON LP cylinder.
2.  Open lid during lighting.
3.  Swing match hole plate to expose match lighting hole.  
Place lit match into match lighting hole of appliance 
as pictured below.  Make sure lit match is placed 
inside hole and near burner.
4.  Push in and turn control knob to       Be sure burner 
lights and stays lit.
5.  Once lit, swing match hole plate back to cover up 
match lighting hole.  Caution: Plate maybe hot.
Match
Control
Knob
Match 
Hole 
Plate
Match 
Lighting 
Hole
Swing Plate to 
expose 
Matchlighting 
Hole
• Apartment Dwellers:
  Check with management to learn the requirements and 
fire codes for using an LP gas appliance in your 
apartment complex. If allowed, use outside on the 
ground floor with a three (3) foot clearance from walls or 
rails. Do not use on or under balconies.
View is from side of appliance
Burner Flame Check
•  Light burner. Looking through viewing hole on top of 
appliance, you should see the flame height as shown 
below. Turn control  knob from      to      OFF.  The Flame 
height should decrease and then go out. Always check 
flame prior to each use. If only low flame is seen refer to 
"Sudden drop or low flame" in the Troubleshooting 
Section.
Low Flame
High Flame
Turning Appliance Off
•  Turn control knob to       position. Turn LP cylinder OFF 
off by turning hand-wheel clockwise to a full stop.
Ignitor Check
•   Turn gas off at LP cylinder. Turn ignitor knob. "Click" 
should be heard each time at electrode. See 
"Troubleshooting" if no click or spark.
Valve Check
•  Important: Make sure gas is off at LP cylinder before 
checking valve.  Knob locks in       position. To OFF 
check valve, first push in knob and release, knob should 
spring back. If knob does not spring back, replace valve 
assembly before using this appliance. Turn knob to     
position then turn back to        position. Valve should OFF 
turn smoothly.  
Hose Check
•  Before each use, check to see if hose is cut, worn or 
kinked. Replace damaged hose before using applaince. 
Use only valve/hose/regulator specified by 
manufacturer.
General Appliance Cleaning 
•    Meat Thermometer: Do not immerse or soak in water. 
Wash with warm soapy water and wipe dry.
•  Do not mistake brown or black accumulation of grease 
and smoke for paint.  Interiors are not painted at the 
factory (and should never be painted). Apply a strong 
solution of detergent and water or use a grill cleaner with 
scrub brush on insides of appliance lid and bottom. 
Rinse and allow to completely air dry. Do not apply a 
caustic grill/oven cleaner to painted surfaces. A black 
surface improves the appliances performance.
•    Plastic parts: Wash with warm soapy water and wipe 
dry.
 Do not use citrisol, abrasive cleaners, degreasers or a 
concentrated grill cleaner on plastic parts. Damage to 
and failure of parts can result. 
•   Painted surfaces: Wash with mild detergent or non-
abrasive cleaner and warm soapy water. Wipe dry with a 
soft non-abrasive cloth.
Normal
Hose
Kinked
Hose
3 ft.
3 ft.
24”