
Installation steps
1.
Select on your chosen surface where you would like to position
your invisible charger. We suggest that you test that a compatible
phone can charge through the surface before proceeding. Please
do not place device directly onto unit, always keep a minimum
distance of 15mm.
2. Plug the adaptor into the charger and attach the IC30 under the
surface of your chosen location using the sticking pad and/or the
anti the screws.
3. Plug the power adaptor into the mains, a green light will indicate
power is on.
4. If using a marker/sticker use the LED alignment sensor to identify
the optimum location.
5 Place the LED sensor on top of the surface directly above the
charger, move around until all 6 LED lights are illuminated. Li the
bottom section & remove the adhesive tape to stick in place. Li &
push out the round centre, lower back onto the surface and place
your marker in the middle of the circle.
6. Place your device to charge, a solid green light will indicate it
is charging.
Qi/MagSafe
Compatible Device
Maximum Surface
Thickness 30mm*
Minimum Surface
Thickness 15mm