Charnwood W650 User manual

W650 Table Saw
Blade Alignment Instructions
1) Disconnect the saw from the power supply and remove the blue panel
from side of the saw base.
2) Loosen, but do not fully undo, the four M8 hex cap head bolts under the
front and rear of the cast table using a 6mm hex key.
M8 Hex Cap Screws
3) Similarly, loosen the two M6 hex cap head bolts accessed through the
side of the base under the sliding table, using a 5mm hex key.
M6 Cap Head Screws

Tel. [phone] Fax. [phone] email: [email protected]
Website: www.charnwood.net
Charnwood, Cedar Court, Walker Road, Bardon, Leicestershire, LE67 TU, England
4) Adjust the alignment of the sawblade in the table insert slot by
moving the cast iron table over the base.
5) Measure the distance between the blade and the T slot in the table at
both the front and rear of the blade, ensuring that both
measurements are the same. Also, ensure that the blade will clear the
table and insert when tilted to 45 degrees.
6) When you are satisfied the blade is aligned, re-tighten the six bolts
and replace the side panel prior to use.