
Key, doors and windows 9
hazard warning lamp will flash once,
and the anti-theft state is released.
: liftgate unlock button. Press and
hold for about 2s; open the liftgate,
and the hazard warning lamp will flash
once.
The functioning range of the
remote control may be
different due to environmental
reasons. Radio interference
signals and barriers will affect
the remote control functions.
Vehicle locating
Press the remote unlock button
quickly for two times to activate the
vehicle locating function, and the
hazard warning lamp will flash for 20
times.
Remote Window Lowering
Press and hold the unlock button for
about 2s to lower all windows
automatically and in turn.
Remote Opening/Closing of
Panoramic Sunroof
If the vehicle is configured with a
panoramic sunroof, press the unlock
button/lock button of the remote control
for about 2s, the sun blind and sunroof
will be opened/closed automatically.
Activation of Door Lock and Anti-
theft Mode
1. Close all the windows.
2. Turn the ignition key to LOCK
position and pull out the key (if
mechanical ignition key is
configured).
3. All passengers leave the vehicle.
4. Close all doors and the enginehood.
5. Press and release the remote lock
button. All doors are locked. The
hazard warning lamp will flash twice,
and the immobilizer is activated.
As for a vehicle configured with ENGINE
START STOP function, only when the
ignition switch is at LOCK position can
the transmitter activates the immobilizer
system.
The anti-theft mode must be
activated with the transmitter.
Warning sound
Under the anti-theft state, when the
unlock button on the transmitter is not
pressed and any of the doors or
liftgate is forced opened in an
abnormal way (including use of a key),
the system will make the hazard
warning lamp flash and emit warning
sound.
To stop warning sound
Press and hold the lock, unlock or
liftgate button on the transmitter for
about 2s or turn the key to ON position
to top the warning sound; if not, the
warning sound will be ended
automatically after 30s, and the anti-
theft mode is activated again. If the
system fails to do so, it is
recommended to have the system
checked by the Aftersales Service
Center.