CHIEF FSB-4394 User manual

INSTALLATION INSTRUCTIONS
CHIEF MANUFACTURING INC. 8804-000328
1-800-582-6480 952-894-6280 FAX [phone] Chief Manufacturing
8401 EAGLE CREEK PKWY, STE. 700 www.chiefmfg.com
SAVAGE, MINNESOTA 55378 USA 09/06
SMALL FLAT PANEL DISPLAY MOUNTING BRACKET
FSB-4394
(1) FSB Interface Bracket (4) Mounting Buttons
(4) 10-24 x .5 Button Head Cap Screw (4) .875 x .33 x .375 Nylon Washer
(4) M4 x 20mm Phillips Head Cap Screw (4) M4 x 25mm Phillips Head Cap Screw
(4) M4 x 40mm Phillips Head Cap Screw (1) 1/8 Allen Key
(4) M4 x 16mm Phillips Head Cap Screw (4) M4 Shoulder washers
(4) M4 Flat washers
BEFORE PROCEEDING: Unpack the carton, verify contents shown in Figure 1 and read
installation instructions completely. If you are missing any of the listed components, please
contact Customer Service at 1-800/582-6480.
Displays are Extremely Fragile.
NOTE: If installing screen onto a VESA 100mm X 100mm mount, skip to step 2 on Page 2 (mounting button
installation is not required).
1. Using #10-24 screws secure mounting button to bracket, with chamfered hole of mounting
button (larger surface) facing bracket (4 places) (see Figure 2 and Figure 3).
CAUTION!
Figure 1
Figure 2 Figure 3

2. Place nylon spacers on mounting holes, aligning hole pattern on brackets with pattern on
back of display (see Figure 3 and Figure 4).
3. Using the proper length of M4 screws (depending on screen), secure bracket to display. Do not over
tighten screws.
4. For Chief Q2™ mounts with 5” X 5” Mounting System - With the aid of another person,
lift the display up to the mount, align the mounting buttons on the plasma with the slots in the
mount, and set the screen into place. Lower safety latch on the Chief Mount to secure your
display, making sure latch is completely engaged.
5. For VESA 100mm X 100mm Mounting Systems - With the aid of another person, lift
display up to the mount, align threaded holes of interface bracket to mounting holes of
mount. Attach screen to mount (per mount instructions) with M4 screws provided with
mount.
6. For Chief Q2™ mounts with 100mm X 100mm Mounting System – Using the buttons
from the mount, secure the buttons with the 16mm M4 screws that come with bracket.
Follow the diagrams below for button mounting. With the aid of another person, lift the
display up to the mount, align the mounting buttons on the plasma with the slots in the
mount, and set the screen into place. Lower safety latch on the Chief Mount to secure your
display, making sure latch is completely engaged.
ALL COMPONENTS MUST BE SECURELY FASTENED TO A
STRUCTURAL MEMBER CAPABLE OF SUPPORTING 4 TIMES
THE COMBINED WEIGHT OF ALL COMPONENTS PLUS THE
EQUIPMENT BEING MOUNTED. IF IT CANNOT SUPPORT
THIS WEIGHT, THE STRUCTURE MUST BE REINFORCED.
THE MAXIMUM WEIGHT TO BE INSTALLED ON THE
BRACKET IS 45 POUNDS (20.41 KG).
WARNING
Figure 3 Figure 4
Figure 5 Figure 6