CHIEF PSM-2051 User manual

INSTALLATION INSTRUCTIONS
PLASMA DISPLAY STATIC MOUNT
PSM-2051 and PSM-2052
(1) Plasma Static Mount (1) 10-24 x .5 FH Undercut Screw
(1) Latching Flag (1) 10-24 Nylock Nut
(4) M8 x 40mm Button Head Cap Screws (4) Mounting Buttons-Nylon
(1) Nylon Washer (1) M5 Allen Key
BEFORE PROCEEDING: Unpack the carton, verify contents shown in Figure 1, and read
installation instructions completely.
Plasma Displays are Extremely Fragile.
1. Secure latching flag to the inside mounting hole of the mount using the 10-24 Philips screw,
nylon washer, and Nylock nut (see Figure 2). Tighten until friction will hold the flag in
place.
2. Attach mounting buttons to display using the M8 bolts. Tighten using the included Allen key
(see Figure 3 and Figure 4).
CAUTION!
Figure 2 Figure 3 Figure 4
ZCube 10/23/03ZCube 10/23/03

ALL COMPONENTS MUST BE SECURELY FASTENED
TO A STRUCTURAL MEMBER CAPABLE OF
SUPPORTING 4 TIMES THE COMBINED WEIGHT OF
ALL COMPONENTS PLUS THE EQUIPMENT BEING
MOUNTED. IF IT CANNOT SUPPORT THIS WEIGHT,
THE STRUCTURE MUST BE REINFORCED.
THE MAXIMUM WEIGHT TO BE INSTALLED ON
THE MOUNT IS 150 POUNDS (68.04 KG).
3. Securely anchor the static mount to the wall using wall studs or supporting framework.
4. Make sure the flag is lowered to the side before attempting to place the display on the mount.
5. With the aid of another person, lift the display up to the mount, align the mounting buttons
on the display with the teardrop slots in the mount, and set the display into place (see
Figure 5).
6. Position (raise) the flag to secure the display (see Figure 5).
Figure 5
WARNNG!