CHIEF PAC-390 User manual

8800-000047 11/05/04
CHIEF MANUFACTURING INC. 1-800-582-6480, Fax: [phone], Email: [email protected]
INSTALLATION INSTRUCTIONS
PAC-390
CUBE WALL HANGER ACCESSORY
Prior to assembly, unpack carton completely and verify contents.
If you are missing any of the following components, please contact Customer Service at 1-800/582-6480
(2) BRACKET, Front (4) WASHER, 1/4” Flat
(2) BRACKET, Front (4) WASHER, 5/16” Flat
(4) BOLT, 1/4”-20 (4) WASHER, 5/16” Lock
(4) BOLT, 5/16”-18 Carriage (4) NUT, 5/16”-18
BEFORE PROCEEDING, READ INSTALLATION INSTRUCTIONS COMPLETELY
LARGE FLAT SCREEN DISPLAYS ARE EXTREMELY
FRAGILE.
1. Using two ¼”-20 bolts and flat washers , attach a rear bracket to a front bracket (see Figure 2). Repeat for this
process for remaining brackets.
CAUTION!
Figure 1
Figure 2

8800-000047 11/05/04
CHIEF MANUFACTURING INC. 1-800-582-6480, Fax: [phone], Email: [email protected]
2. Attach wall mount to hangers using four 5/16”-18 carriage bolts, four flat washers, four lock washers,
and four lock nuts (see Figure 3).
3. Place hanger, with mount, over cube wall.
4. Adjust top plate to width of cube wall (see Figure 4).
5. Install display/PSB assembly on mount.
Figure 3
Figure 4