PSS2000 Installation Instructions
6
3. Install faceplate into upper mounting holes of slide using
two flat washers and two lock nuts removed in Step 2.
4. Install slide onto base using four button head cap screws
and four flat washers removed in Step 1.
NOTE:
Do NOT fully tighten slide mounting screws at this time.
5. Raise slide to maximum height.
6. Tighten four height adjustment screws. (See Figure 2)
Site Preparation
WARNING:
EXCEEDING WEIGHT CAPACITY CAN
RESULT IN SERIOUS PERSONAL INJURY OR DAMAGE
TO EQUIPMENT! It is the installer’s responsibility to make
sure the combined weight of all components does not exceed
150 lbs (68.04 kg).
CAUTION:
TURNING DISPLAY CAN CAUSE DAMAGE
TO SURROUNDING OBJECTS. Make certain location
provides enough area for the display to rotate + 45° without
being obstructed.
NOTE:
See Display Stop Location Adjustment section for
information on adjusting rotation.
1. Locate a flat dry surface on which to mount the PSS2000
assembly.
2. Measure the hole locations on bottom of PSS2000 and
mark the four mounting hole locations on mounting surface.
(See Figure 4)
Figure 4
3. Drill four 1/4" diameter holes through mounting surface at
marks.
4. Secure mount to mounting surface using four 1/4-20 cap
screws with a length equal to the thickness of the mounting
surface Aplus 3/4". (See Figure 4)
Display Installation
The following procedure assumes that the proper interface
bracket for the display being mounted has already been
installed on the display.
If no interface bracket is present on display, install bracket to
display using the instructions included with the interface bracket
before proceeding.
If an interface bracket for the display being mounted needs to
be obtained, or additional assistance is required, contact Chief.
To install the display:
1. While supporting both sides of display, align four mounting
buttons on display or interface bracket with four mounting
holes in faceplate.
2. Lower display into place listening for audible "click" to
ensure recessed area of mounting buttons are properly
seated in lower area of mounting holes and ClickConnect
mechanism has engaged. (See Figure 1)
NOTE:
Holes are provided in the faceplate for use with a
padlock orsimilarlockingdevice,ifdesired.Inaddition,
the pin and nut may be removed from the upper holes
and moved to the lower holes for use as a more
permanent locking device.
Figure 5
x 4
1
x 4
4
PSS2000
3/4"
A
x 4
2
3
2
To use as a more
permanent lock,
remove pin and
nuts and
move to
lower holes.
1
A padlock or bolt may be
placed through latch holes
