Installation Instructions PLP Series
3
PLP ASSEMBLY
WARNING: The PLP must be installed with correct end,
indicated by “Mount This Side Up”, on top.
WARNING: It is the responsibility of the installer to verify
that the wall to which the PLP is anchored will
safety support the combined load of all
attached components and equipment.
With the PLP correctly oriented (Mount This Side Up) and
level, secure the PLP to the wall using a minimum of four
fasteners (not included). Fasteners must be driven into the
supporting wall studs or other supporting framework.
Mount the Display
1. Make sure no power is supplied to the display and the flag
is in the up position before attempting to mount the dis-
play.
2. Using two people, slide the display down over the PLP.
Make sure all four Quick Latches (Q-Latches) of the dis-
play engage all four slots in the PLP.
3. With the Q-Latches of the display fully engaged in the
slots of the PLP, secure the display on the PLP by lowering
the flag all the way down to the locked position. If the flag
does not fully engage, remove the display and make sure
the brackets are correctly installed.
NOTE: A security lock may be installed through the hole in the
flag for additional security.
NOTE: If display does not remain at desired tilt setting, tighten
the bolt on the tilt arm on each side.
WARNING: Make sure the flag securing the display is com-
pletely lowered at all times except when
removing or installing the display. The flag
must be all the way down when installing/
removing cables.
4. If necessary, pull the bottom of the display up and out to
install power/audio/video cables. Lower the two latches to
prevent the display from moving back, making sure the
safety bar lowers into to secure the latches.
WARNING: Watch for pinch points. Do not put your fin-
gers between movable parts.
5. Raise and lower latches (A) by raising and lowering the
center support bar, being careful not to pinch fingers,
return the bottom of the display.
Optional Security Lock Here
Center Support Bar
Front View
Tighten bolt on
display angle
each sideto secure
A
Side View
