Chieftec SNT-2131 SATA User manual

SNT-2131 SATA Back Plane
User’s Manual
Features of product ---
 Aluminum Frame, Aluminum cover
 Interface: Support SATA-I, SATA-II
 High performance transfer rate up to 150MB/s, 300MB/s
 Plug & play, hot swappable
 Point to point, free from master/slave setting
 SATA 15Pin & Molex 4Pin Power connectors
 LED for PSU , HDD access, Fan sensor & Buzzer
 Power Control Switch
 Reset Switch for buzzer alarm
 8cm FAN X1
 Magic Handle—Auto In/Out
 Color for choice: black
 Dimension: 202(L) X 146(W) X 86(H) mm
 Patent products with advanced structure design
 Precisely connection on connector (see picture A)
---Caddy Drive Drawer Install---
Use TM#6*4 long screws to mount the drive in the drawer. (see picture C)

---Front Panel--- (see picture D)
D.1--- Reset Switch for buzzer alarm and
Overheating LED
When overheatin
g
occurs the buzzer
alarms (default setting: 60°C and the
temperature LED turns red meanwhile
buzzer is alarming and LED is blinkin
g
).
press the Reset Switch to stop the alarm,
and LED goes off.
D.2--- D.4 (HD1〜HD3, Power SW and LED:
Power on, LED indicates Green. Oran
g
e
color blinking for HDD access)
D.5--- Fan sensor LED: LED is indicatin
g
Green when it is working. When the fan
fails, LED turns Red.
D.6--- Safety Lock
The safety lock safe
g
uards the hard disk
in the correct position and prevents it
bouncin
g
out while HDD is workin
g
. (see
Picture E)
Picture E
POWER1: 4pin Power connector
POWER2: 15pin Serial ATA Power
connector
HD1—HD3: 7pin Serial ATA Signal
con
in
ower
r.
can mix using 4pin and 15pin
r
ch for buzzer alarm and
ture detection (red)
ture detection (green)
J4: FAN RPM HIGH & LOW Optional
nector
If your power is not from SATA 15p
connector, please use the 4pin p
connector. The 4pin power will
automatically be converted to SATA powe
(Note: you
powers）
lJP1: Temperature setting jumpe
lJP3: Extension function jumper
FLEDR: Fan failure detection (red)
FLED+: Fan failure detection (+)
FLEDG: Fan failure detection (green)
RESET: Reset Swit
Overheating LED
TLEDR: Tempera
5V+: 5V Power
TLEDG：Tempera
GND：Grounded
---Rear View--- (see picture F)
Picture F