Chigo SMART BOX Operating manual

I
WIFI SMART
Users and installation manual
ZM01Eng-0

II
CONTENT
1.Port introduction............................................................. 1
2. APPdownload................................................................ 1
3.Connecting to phone/pad.................................................. 2

1
WIFI smart centralized controller, also called SMART BOX, is supported
by PC (IE9 or Chrome)、iOS (system more than 7.0 ) and Android. ( It
requires the device's resolution of more than720*1280. We suggest you
use 720*1280 and 1080*1920)
1.Port introduction
CON: Connect to phone/pad
DA: Data LED
OL: Online LED
PW: Power LED
POWER: Power（5V，1.5A）
XYE: 485 Port （connect to outdoor XYE port ）
R：Reserve
2. APP download
1) iOS users can download “SMART AC”in APP store for free.
2) iOS and Android cellphone user can download by scan the attached
QR code below.

2
3.Connecting to phone/pad
1) Smart box connect to the router
1.1) Long press SMART BOX’s CON button, until OL light turn into the
flash state;
1.2) Turn on phone/pad WIFI and connect to wireless router’s WIFI;
1.3) Then open SMARTAC app on phone/pad;
1.4) Find the download “Smart AC”APP and enter, shown as below;
1.5) Touch “Controller configuration set”then enter SMART BOX
configuration interface, shown as below;

3
Router Name: WIFI currently connected
Router Pass: Input currently connected WIFI password manually.
1.6) Click “Configuration”, shown as below;
1.7) About 40s, it will display “Configuration success”, and enter into the
following interface.

4
2) Control by WAN remotely
2.1) Input “User Name”and “Password”, enter the “Add Controller”
interface , shown as below; (The first user please press “Register” to
register a new account )
MAC Address: Default
Binding password: Input by yourself in case of someone connect to this
box and control VRF system
Contrlller name: Default (free to name )
Address: Default (free to name )
2.2) After input information , touch “Confirm” ,and enter into the
following interface;

5
2.3) Touch “Unit control”enter into the Controller list interface;
2.4) Touch “>”enter into indoor unit control interface;
2.5) Repeat 1.1-1.7 and 2.1-2.4 step , if add other Controllers . (one PC or
one phone can connect max 4 Controllers)
3) Control by LAN
3.1) On Login interface , click “Home control” and enter into controller
list interface ,show as below;

6
3.2) Click button as above , then turn into the following interface ;
3.3) Click “>”button as above , scan the device , then turn into the
following interface;
3.4) Click “>” as above, then turn into the indoor unit control list .
4) Control by PC
Website : http://119.145.169.14:9090/AC/ , input user name and password
then enter into control interface as cellphone .
(Controller configuration is only available on cellphone )
QR Code