Choice 407ONSLIC14 User manual

User Manual
Item # 407ONSLIC14
1/4”
Item # 407ONSLIC316
3/16”
07/2020
Onion Slicers

Safety Instructions
Be careful when handling and operating the machine, as the blades are very sharp. Always keep
your hands away from the blades. When not in use, use the ring pin to secure the machine in the
lockdown position.
Operation
1) Remove ring pin from lockdown position hole and place in the hole on the handle.
2) Use the handle to raise the push plate to the upright position.
3) Carefully place produce on the blade surface. Make sure the produce isn’t larger than the
blade surface.
a. Note: For proper functionality and slice size make sure the two appropriate blade
cartridges are set on top of one another.
4) Makesurehandsandngersareclearofthecuttingarea.
5) Withonerm,swiftmotionbringthehandledownuntilthepushplatepushesthe
produce completely through the blade cartridges.
Cleaning and Maintenance
1) To remove pusher assembly remove the ring pin and use the handle to lift the pusher
assembly off of the guide rods.
2) Carefully remove blade assemblies from the main frame one at a time.
3) Thoroughly clean the frame, blade assemblies, and pusher assembly.
4) Dry all components then replace the blade assemblies, pusher assembly, and ring pin.
5) If necessary lubricate the guide rods with food grade mineral oil. Do NOT use cooking or
vegetable oil.
Please read and comply with the instructions listed on this document. To get the best
service life and performance from your machine, clean it thoroughly before and after each
use by following the instructions listed below. Minimize the use of alkaline cleaners as
theymaydullthenishandcausepitting.
User Manual
Onion Slicers

Replacement Parts
User Manual
Onion Slicers
3/16” Blade Set
#407ONBLD316
1/4” Blade Set
#407ONBLD14
1/4” Pusher Plate
#407ONPUSH14
3/16” Pusher Plate
#407ONPUSH316
Non-Skid Foot
#407NSKIDFEET
Bumper
#181BUMPER2
Chain and Pin
Assembly
#181CHAINPIN
Bushing
#181BUSHING2