
Operating Instructions
Starting the Oven for the first time:
1. Load the oven with the desired amount of flux
2. Ensure the door is fully shut
3. Check that the power connections are secure
4. Turn the oven on via the main switch and check for power
5. After 10 seconds the thermoregulators are able to be programmed to the desired conditions.
Altering the temperature and time set-points
In cases where a custom programme is required, please follow the instructions below:
a) ADJUSTMENT OF THE HEATING ELEMENTS CONTROL AND SAFETY THERMOREGULATOR (°C heating
element) : press and release the key L1 : the L1 led starts flashing, 1SP is displayed for one second , then
the value linked to the setpoint appears; press LEFT or RIGHT to change the value ; the new value and
the return to normal mode can be saved; the same happens after 10 seconds of inactivity. Press 0/1 to
return to normal mode without saving any value.
b) ADJUSTMENT OF THE OVEN-ENVIRONMENT THERMOREGULATOR (°C oven- environment) at active
“SET POINT” stage (SP1 or SP2
). Cycle SP1
(drying): pressing the “P” key (for 1 sec.max.) , the SP1
adjustment is activated; act on UP and DOWN and set the required temperature (400°C max.); enter
by pressing the P” key (for max. 1 sec.)
After 6 hours (the time is adjustable from MENU as per following description) you can go to: Cycle SP2
(keeping): pressing the “P” key (for 1 sec.max.), the SP2 adjustment is activated; act on UP and DOWN
set the required temperature (200°C max.); enter by pressing the “P” key (for 1 second max.) During the
programming time checking is halted
c) ADJUSTMENT OF THE OVEN-ENVIRONMENT THERMOREGULATOR (°C oven- environment) at inactive
“SET-POINT” stage (SP1 – SP2
): The programming menu is activated pressing on “P” key for more than 2
seconds.
Through UP and DOWN keys, select ‘’OPER’’ and confirm with the ‘’P’’ key. Select by UP/DOWN and
choose “SP2”, enter by pressing “P”, 120° (or last programming) appears, select by UP/DOWN until the
required value is achieved, enter by pressing “P” key.
( The thermoregulator gets back to start, whether no change is done in 20 seconds)
Drying Time Programming (T Lasting)
The programming menu is activated pressing on “P” key for more than 2 seconds.
Through UP & DOWN keys, select ‘’OPER’’ and confirm with the ‘’P’’ key. ‘’SP” appears, select by UP
/DOWN keys, “
]
REG” appears, press “P” and time last. appears, press “P” and 6.00 (last programming
stated in hours, min.) appears, select by UP/DOWN keys, until the required value is achieved, enter by
pressing “P” key. (The thermo regulator gets back to start, if no change is completed within 20 seconds).
It is necessary to switch the oven off and switch it on again when you change the parameters to
apply them.