www.cipherlab.com
>
2200 Series Locking Mount Bracket
Quick Start Guide
Illustration of Screw Hole Size
Package Content:
a
a
a
1. Place this illustration on a proper position like wall or desk and fix it.
2. Drill the holes according to the marks (5mm in diameter, 25mm deep).
Locking Mount Bracket * 1
Philips Tapping Screws (Diameter=5mm; Length=19mm) * 4
Plastic Anchors (Inner Diameter=3.2mm; Length=22mm) * 4
55 mm
50 mm
5mm
11:
Instructions
Desktop Installation
>>
For desktop position, follow the steps listed below:
1. Consider to leave enough space for cable deployment around the
scanner in advance. Place the locking mount bracket to the target
position on the desk, drill four holes respectively through the bracket
holes.
2. Secure the bracket with the included tapping screws.
After fixing the bracket, slide the bottom of the scanner forward along the
bracket rails until the end.
tapping screw
locking mount bracket
1
2
bracket rails
Wall-mount Installation
For wall mount position, follow the steps listed below:
1. After you fix the illustration to the target position, respectively drill four
holes on the wall.
2. Push the screw anchors to their full depth into the holes.
3. Place the locking mount bracket by aligning the bracket holes with anchor
holes.
4. Insert the screws through the bracket, and screw them into the anchors.
tapping screw
locking mount bracket
screw anchor
illustration paper
50 mm
55 mm
After fixing the bracket, slide the bottom of the scanner facing down along
the bracket rails until the end.
1
2
3
4
bracket rails
