CIPTON CPTN4003 User manual

LED Light Up
Basketball Kit
Instruction Manual
CPTN4003

Before You Begin...
READ CAREFULLY AND KEEP THIS MANUAL FOR
FUTURE REFERENCE
General Warnings
• Adult supervision required.
• Do not use in the rain, sleet or snow. Keep away from water and extreme
temperatures.
• Adult supervision is required when performing any maintenance on the ball.
• The ball, wrist bands and remote control come with built-in batteries which should
not be disposed of with regular household waste. Follow all local laws and
regulations in disposing of batteries.
• Do not open these products or attempt to repair the units yourself should they not
be working.
• Do not expose the units to extreme temperatures (heat or cold), open ames, humid
conditions, or wet conditions.
• Do not submerge in water.
In the Box
• Basketball (x1)
• 5-ft. Rim Light with Remote Control (x1)
• Adhesive Hook-and-Loop Fastener (x1)
• Hook-and-Loop Fastener Strips (x8)
• LED Bracelets (x6)
• 12” Air Pump (x1)
• Carrying Bag (x1)
• Instruction Manual (x1)

Using the Basketball
Inating the Basketball
1. Attach an ination needle onto the included ball pump.
2. Carefully stick the ination needle into the valve on the ball.
3. Pull and push the handle on the back of the ball pump to pump up the ball to a PSI
of between 7 and 9. Be careful not to over-inate the ball, as this can pop it.
4. When nished, remove the ination needle from the ball, and store the ball pump
away.
Basketball LED Setup
• The ball comes with batteries already installed. Pull the tab marked “PULL” to remove
the spacer insulating the batteries.
• To activate the lights, bounce the ball. The lights are impact-activated.
• If the spacer is broken and cannot be pulled out, or if the ball does not light up after
the spacer is removed, try following the steps in the Replacing the Batteries section
below to re-install the light unit or replace the batteries.
Replacing the Basketball Batteries
CAUTION: Do not sure a sharp tool to open the cap. It is recommended to use a key.
These procedures should be done carefully, under adult supervision ONLY.
Keep all batteries, wrenches, plastic bags and other accessories away from babies,
children and pets. They are NOT toys. They can cause injury, suocation, poisoning or
other dangers.
(Continued on the next page)

STEP 1
Deate the ball slightly and
use a non-sharp tool such as a
key to pry open the end cap.
Do not use a sharp tool as this
many damage the ball.
STEP 2
Use the hook of the tool to
pull out the light unit.
STEP 3
Pull the transparent tube
containing the batteries
out of the unit.
Replacing the Basketball Batteries (cont’d)
+
+
+
STEP 4
Use the tool to push the
batteries out of the unit
as shown above.
STEP 5
Insert 3 new LR44 coin cell
batteries with the positive poles
facing down. Do not mix old and
new batteries, or mix dierent
types or brands of battery.
STEP 6
Place the transparent tube
of batteries back into the
light unit.
STEP 7
Return the light unit into
its container in the ball.
STEP 8
Replace the cap, with the
textured side facing
outward. Press into the ball
until secured.
STEP 9
Use the assembly tool to
adjust the cap so that it is
at against the ball surface.

Using the Rim Lights
Rim Light Battery Installation
1. Undo the 2 clasps on the rim lights’attached battery compartment, and open the
compartment.
2. Install 3 AA-sized Alkaline batteries, following the polarity (+/-) diagram in the
compartment. Do not mix old and new batteries, or mix dierent brands or types of
battery.
3. Close the compartment, and lock the 2 clasps.
Rim Light Installation
1. Install batteries according to the instructions above.
2. Mount the battery pack to your backboard using the included 3M™ adhesive
hook-and-loop fastener.
• Peel o one side’s adhesive, stick on the battery pack. Press and hold for 1 minute.
• Peel o the other side’s adhesive, stick on desired location. Press + hold for 1 min.
3. Secure the lights to the rim by wrapping the included hook-and-loop fastener strips in
tight circles around.
Using the Rim Lights
• Press the button on the outside of the battery pack to turn the rim lights ON.
• Press the button additional times to ip through the dierent modes, and to turn the
lights OFF.
• The rim lights can also be controlled with the included remote control. See the Using
the Rim Lights Remote Control section below for details.
Using the Rim Lights Remote Control
1. Set up and install the rim lights according to the above instructions.
2. Remove the plastic tab sticking out of the bottom of the remote control.
3. Press the remote control buttoms to turn the rim lights ON/OFF, change colors, and
set an automatic shuto timer.

Using the LED Bracelets
LED Bracelet Setup
The LED bracelets come with batteries already installed.
To activate the LED bracelets, remove the plastic tabs sticking out of the sides of the
battery units.
Opening/Closing the Bracelet
• To open the bracelet, pull apart at the
clasp near the top of the bracelet. See
photo at right.
• To close the bracelet, line the clasp up,
and push closed.
Powering ON/OFF
• Press the button on the side of the
bracelet’s battery pack to power the
LED lights ON.
• Press the button additional times to
ip through the dierent LED light
colors and modes.
• Press and hold the button to power the LED lights OFF.
Note: You MUST remove the plastic tab to activate the batteries before the LED lights
will work. If the lights are not working, check to make sure you have pulled out the tab.

FCC Information
This device complies with Part 15 of the FCC Rules.
Caution: Any changes or modications not expressly approved could void the user's authority to operate
the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment o and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Rating Label Denitions
Compliance Information
This symbol signies the product must not be discarded as household waste, and should be delivered to an
appropriate collection facility for recycling. Proper disposal and recycling helps protect natural resources,
human health and the environment.

Warranty Information
All product names, trademarks, and registered trademarks are property of
their respective owners. All company, product, and service names used in this
document are for identication purposes only. Use of these names, trademarks,
and brands does not imply endorsement.
Printed in China
Designed in USA
v1. 08-2021
90-Day Limited Warranty
Territory: United States/Canada
LIMITED WARRANTY TO ORIGINAL CONSUMER
This product as supplied and distributed new by an authorized retailer is warranted by Southern Telecom, Inc. to the original
consumer purchaser against defects in materials and workmanship (“Warranty”) as follows:
To obtain warranty service:
• Visit our customer support portal: www.customersupport123.com
• Select the brand and model of your device
• Select “Service Request” and ll out the form to begin your inquiry
• Exchanges require dated proof of purchase from an authorized retailer
Your product will be repaired or replaced, at our option, for the same or similar model of equal value if examination by the service
center determines this product is defective. Products received damaged as a result of shipping will require you to le a claim with
the carrier.
Warranty service not provided
This warranty does not cover damage resulting from accident, misuse, abuse, improper installation or operation, lack of reasonable
care, unauthorized modication including software modications such as the installation of custom rmware. This warranty is
voided in the event any unauthorized person opens, alters or repairs this product. All products being returned to the authorized
service center for repair must be suitably packaged.
NO WARRANTIES, WHETHER EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITEDTO, ANY IMPLIED WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, OTHER THAN THOSE EXPRESSLY DESCRIBED ABOVE SHALL APPLY.
DISTRIBUTOR FURTHER DISCLAIMS ALL WARRANTIES AFTER THE EXPRESS WARRANTY PERIOD STATED ABOVE. NO OTHER EXPRESS
WARRANTY OR GUARANTY GIVEN BY ANY PERSON, FIRM OR ENTITY WITH RESPECT TO THE PRODUCT SHALL BE BINDING ON
DISTRIBUTOR. REPAIR, REPLACEMENT, OR REFUND OF THE ORIGINAL PURCHASE PRICE - AT DISTRIBUTOR’S SOLE DISCRETION - ARE
THE EXCLUSIVE REMEDIES OF THE CONSUMER. IN NO EVENT WILL DISTRIBUTOR OR ITS MANUFACTURERS BE LIABLE FOR ANY
INCIDENTAL, DIRECT, INDIRECT, SPECIAL, PUNITIVE OR CONSEQUENTIAL DAMAGES (SUCH AS, BUT NOT LIMITED TO, DAMAGES FOR
LOSS OF PROFITS, BUSINESS, SAVINGS, DATA OR RECORDS) CAUSED BY THE USE, MISUSE OR INABILITY TO USE THE PRODUCT.
EXCEPT AS STATED HEREIN, NO OTHER WARRANTIES SHALL APPLY. NOTWITHSTANDING THE FOREGOING, CONSUMER’S RECOVERY
AGAINST DISTRIBUTOR SHALL NOT EXCEED THE PURCHASE PRICE OF THE PRODUCT SOLD BY DISTRIBUTOR. THIS WARRANTY SHALL
NOT EXTEND TO ANYONE OTHER THAN THE ORIGINAL CONSUMER WHO PURCHASED THE PRODUCT AND IS NOT TRANSFERABLE.
Some countries, states or provinces do not allow the exclusion or limitation of incidental or consequential damages or allow
limitations on warranties, so limitation or exclusions may not apply to you. This warranty gives you specic legal rights, and you may
have other rights that vary from state to state or province to province. Contact your authorized retailer to determine if another
warranty applies.