Bison BA187 User manual

1
 Inspect all contents prior to installation. Report any missing parts to dealer immediately.
 Read all instructions before proceeding.
—— Instruction Manual ——
BA187
Sharpshooter™ Ballcart
1. Orient Tall Frame Side (A) and Short Frame Side (B) so that the big holes are on the outside of the
assembly. See Illustration.
2. Use 1/2"Cap Screws (F) and Bolt Spacers (G) to install the three Short Horizontal Bars (E) between the
Tall Frame Side (A) and Short Frame Side (B). Hand tighten hardware. See Illustration.
3. Use 1/2"Cap Screws (F), Bolt Spacers (G) and 1/2"Hex Nuts (H) to attach Long Horizontal Bar Bracket
(C) to Short Frame Side (B). Hand tighten hardware. See Illustration.
4. Use 1/2"Cap Screws (F) to attach the Long Horizontal Bars (D) between the Tall Frame Side (A) and
Long Horizontal Bar Bracket (C). Hand tighten hardware. See Illustration.
5. Insert the Casters (J) into the bottom of Tall Frame Side (A) and Short Frame Side (B). See Illustration.
6. Place assembled ball cart on a smooth flat surface. Use 3/8"Hex Bit (I) to tighten all hardware.
Note:
Use Caution to keep the Bolt Spacers (G) on the 1/2" Cap Screws (F) during assembly
Date: 08/18/2017 Rev: I.R. B.A. N.J.C. File: \\bisonserver\publisher\BA187.pub Ref#:950498
Customer Service
[phone]
P A R T S L I S T
Item Qty Description Item Qty Description
A 1 Tall Frame Side F 12 1/2” Cap Screw
B 1 Short Frame Side G 8 Bolt Spacer
C 1 Long Horizontal Bar Bracket H 2 1/2" Hex Nut
D 2 Long Horizontal Bar I 1 3/8” Hex Bit
E 3 Short Horizontal Bar J 4 Caster

2