
4-5
Cisco Physical Access Gateway User Guide
OL-20932-01
Chapter 4 Connecting a Cisco Input Module
Installing the Cisco Input Module
Status LEDs
Each input port includes a status LED that indicates the following information:
Installing the Cisco Input Module
Install a Cisco Input Module is provide additional input connections for a Cisco Reader Module or
Gateway
Before You Begin
Verify the following:
•Verify that the module has access to a power source. See Power Options and Requirements,
page 1-10 for more information.
•Verify that you have the necessary mounting brackets or other hardware. See Mounting a Gateway
or Optional Module, page 1-12.
Installation Procedure
To install the module, perform the following procedure:
Step 1 Mount the module to a wall. See Mounting a Gateway or Optional Module, page 1-12 for more
information.
8PF Power fail input: an unsupervised input that raises a “power fail”
alarm when the circuit is open. Can be configured as an additional
unsupervised port. The corresponding LED is red when circuit is
open (when no input is connected).
9TM Tamper input: an unsupervised input that raises a “tamper” alarm
when the circuit is open. Can be configured as an additional
unsupervised port. The corresponding LED is red when circuit is
open (when no input is connected).
Type Description
Table 4-1 Input Module LEDs
Status Description
OFF Input is not configured
GREEN Input is configured and in normal state
BLINKING GREEN Input is configured, and is receiving and alarm or other data.
BLINKING RED Input is configured, short
RED Input is configured, open