Clarion NX302E User manual

11
English
NX302E
Installation Guide
Before Starting
Cautions On Installation
1. Prepare all articles necessary for installing
the main unit before starting.
2. Install the unit within 30° of the horizontal
plane.
3. If you have to do any modication on the
car body, such as drilling holes, consult
your car dealer beforehand.
4. Use the included screws for installation.
Using other screws can cause damage.
Package Contents
Source unit ................................................1
Wire connector ..........................................1
GPS antenna.............................................1
CLAMP for GPS antenna’s cable..............3
DOUBLE FACE TAPE for GPS Antenna...1
Cleaning cloth............................................1
Warranty Card...........................................1
Quick Start Guide......................................1
Car battery 1. This set is exclusively for use in cars with a
negative ground, 12 V power supply.
2. Read these instructions carefully.
3. Be sure to disconnect the battery “ ” terminal
before starting. This is to prevent short circuits
during installation.
Max. 30°
Chassis
Damage
Max. 6 mm (M5 screw)
Owner’s manual (CD-R)............................1
Electro tap .................................................2
Flush mount bolts(M5x6)...........................8
Hexagon Head Screw(M5x6) ....................8
Rear Stud Bolt...........................................1
Rubber Parts .............................................1
AV cable....................................................1

English
12 NX302E
Installing The Main Unit
This unit is designed for xed installation in the dashboard.
1. When installing the main unit in NISSAN vehicles, use the parts attached to the unit (see “
NISSAN”). When installing the main unit in TOYOTA vehicles, use the parts attached to the
vehicle (see “ TOYOTA”).
2. Wire as shown in “Wire Connection”.
3. Reassemble and secure the unit in the dashboard and set the face panel and center panel.
Mounting Screw Holes (Side View of the Main Unit)
NISSAN
6-Spacer (thickness: 1 mm)
8-Hexagonal screw (M5 × 6)
Center Panel *1
Screws marked and mounting bracket are attached to the vehicle.
NISSAN
TOYOTA
6-Flat head screw (M5 × 6)
(attached to the main unit)
Mounting bracket
(1 pair for the left and right sides)
Mounting bracket
(1 pair for the left and right sides)
TOYOTA
*2
Installation Guide

13
English
NX302E
Cautions On Wiring
• Be sure to turn the power off before wiring. Be particularly careful where you route the wires.
• Keep them well away from the engine, and exhaust pipe, etc. Heat may damage the wires.
• If the fuse should blow, check to see if the wiring is correct. If a fuse is blown, replace it with a
new one of the same specication as the original.
• To replace the fuse, remove the old fuse of the power supply cord and insert the new one.
Note:
• Therearevarioustypesoffuseholder.Donotletthebatterysidetouchothermetalparts.
Note:
*1Somepanelopeningsaretoosmallfortheunitdependingonthevehicletypeandmodel.In
suchacase,trimtheupperandlowersidesofthepanelframebyabout0.5to1.5mmsothe
unitcanbeinsertedsmoothly.
*2Ifahookontheinstallationbracketinterfereswiththeunit,bendandflattenitwithanipperor
similartool.
Vehicles other than NISSAN and TOYOTA
In some cases the center panel may require modication. (Trimming, lling, etc.)
Typical Mounting Brackets
In some cases the center panel may require modication. (Trimming, lling, etc.)
Afx the screws to the marks.
• After the connection, x the cord by a clamp or insulation tape for protection.
Fuse (15A FUSE)
Fuse holder
Example 1-3
Installation Guide

English
14 NX302E
Installing The GPS Antenna
WARNING
• Do not install the GPS antenna in a place where it may interfere with the operation of the
airbag or hinder the driver’s visual range.
• Do not use the navigation system with the GPS antenna cord cut off. The power cables in the
cord may be short-circuited.
Note:
• ThesuppliedGPSantennaisforinstallinginsidethevehicle.Donotinstallitoutsidethe
vehicle.
• InstalltheGPSantennamorethan50cmawayfromthemainunit,otheraudiodevicessuch
asCDplayer,andaradardetector.Ifitisinstallednearthesedevices,GPSreceptionmaybe
impaired.
• ToimprovetheGPSsignalreception,installtheGPSantennahorizontallyonaflatplane.
• DonotwaxorpaintthecoveroftheGPSantenna.Thismayreducetheperformanceofthe
GPSantenna.
• InstalltheGPSantennaatleast10cmawayfromthewindshield.
• WipeoffthedirtofthemountingsurfacebeforeinstallingtheGPSantenna.
GPS antenna
• Mount the GPS antenna.
Stick it surely on a at plane of
the passengerside dashboard
where GPS signal interruption is
minimized.
• Wire the GPS antenna cord.
Fasten the cord using the cord
holders.
Cord holder
Double-sided tape
Bottom face of the GPS antenna
• Stick the double-sided tape to the bottom
face of the GPS antenna.
Installation Guide

15
English
NX302E
NX302E
2-Channel Amplifier
Video Out Rear Vision Camera
Yellow
VISUAL IN
Black
Yellow
CAMERA
Black
Steering Wheel Remote Control Terminal
Gray Gray
External Microphone Connection
Black Black
Black
USB connector
Red
White
Line Out Rear Right
Subwoofer 2
Line Out Rear Left
Subwoofer 1
Black
GPS Antenna
(Black)
Video Out
iPod/iPhone
CCA-750
(sold separately)
Radio Antenna
(Black)
C
18
16
14
12
10
8
6
4
2
17
15
13
11
9
7
5
3
1
A
1
3
5
7
2
4
6
8
B
1
3
5
7
2
4
6
8
Phone Mute / Brown
Reverse / Pruple with white stripe Rear right (+) / Purple
Rear right (-) / Purple with black stripe
Rear left (+) / Green
Rear left (-) / Green with black stripe
Front right (+) / Grey
Front right (-) / Grey with black stripe
Front left (+) / White
Front left (-) / White with black stripe
Battery 12V(+) / Yellow
Auto Antenna / Blue
Illumination / Orange with white stripe
ACC+ / Red
Ground / Black
YellowYellow
RedRed
VW , Audi
Battery +
Front left +
Rear left +
Rear right -
Front right -
Rear left -
Front left -
Front right +
Rear right +
Fuse 15A
Refer to next page.
A
B
C
2
4
6
8
1
3
5
7
1
3
5
7
2
4
6
8
Reverse
Phone Mute
Parking
Illumination
Ground
AMP Remote
AUTO ANT
ACC +
USB Memory
or
Wire Connection
Installation Guide
(Black)
(Black)
Radio Antenna
Refer to next page.
Black
VISUAL IN
CAMERA
Black
Gray Gray
Black
Black
or USB Memory
2-Channel Amplier
USB connector
Red Line Out Rear Right
Subwoofer 2
Line Out Rear Left
Subwoofer 1
iPod/iPhone®
Video Out
Video Out
Steering Wheel Remote Control Terminal
Rear Vision Camera
CCA-750
(sold separately)
White
Yellow
Yellow
GPS Antenna
Black Black External Microphone Connection

English
16 NX302E
Installation Guide
C
18
16
14
12
10
8
6
4
2
17
15
13
11
9
7
5
3
1
A
1
3
5
7
2
4
6
8
B
1
3
5
7
2
4
6
8
d
VW, Audi
Rear right (+) / Purple
Rear right (-) / Purple with black stripe
Front right (+) / Gray
Battery 12V(+) / Yellow Front right (-) / Gray with black stripe
Auto Antenna / Blue Front left (+) / White
Illumination / Orange with white stripe Front left (-) / White with black stripe
ACC+ / Red Rear left (+) / Green
Ground / Black Rear left (-) / Green with black stripe
YellowYellow
Red Red
Function
Connector A Connector B
Location
Rear right -
Front right -
Front left +
Rear left +
AUTO ANT
ACC +
Parking
Reverse
Ground
Rear right +
Front right +
Front left -
Rear left -
Illumination
AMP Remote
Phone Mute
Battery + Fuse 15A

17
English
NX302E
Note:
*1ConnecttotheAUXaudioinputterminalandtheiPodvideoinputterminal.(Audioconnection
isrequiredonlywhen[Analog]isselectedfortheiPodoutputsignal.SeeOwner’sManual.)
*2Incertainvehicles-Volkswagen/Opel/Vauxhall-itisnecessarytoexchangetheaccessory
<<Red>>andthemainpower<<Yellow>>connection,toavoidoverloadandlossofmemory.
*3Whentheunitisinstalledina1998orlaterVolkswagenmodel,makesuretointerruptthe
<<Remote>>output.
 Disconnectthe<<blue/white>>wireandinsulatethefrontendsofthiscord.Abreakdownmay
occurifthecordisnotdisconnected,orfrontendsarenotinsulated.
Installation Guide
Connecting the parking brake cord
Connect the cord to parking brake lamp ground in the meter panel.
Note:
 • Connectingtheparkingbrakecordtolampgroundallowsyoutowatchvideoimageswhen
theparkingbrakeisengaged.
 • Whentheparkingbrakecordisnotconnected,themonitorwillnotdisplayvideoimages.
Parking brake lamp
cord to battery
Parking brake
Electro-tap
Parking brake signal cord
Parking brake cord (Grass-green)
Parking brake signal cord
Stopper Parking brake cord (Grass-green)