Clarke STRONG-ARM 7615060 User manual

WARNING: Read these instructions before using the product
USER INSTRUCTIONS
GC0913
7PC ADAPTOR KIT FOR CSA12F &
CSA10BB HYDRAULIC PRESSES
PART NO: 7615060

2
Parts & Service: 020 8988 7400 / E-mail: [e-mail] or Servi[email protected]om
INTRODUCTION
Thank you for purchasing this CLARKE Adaptor Kit.
Before attempting to use this product, it is essential that you read this manual
thoroughly and carefully follow all instructions given. In doing so you will ensure
the safety of yourself and that of others around you, and you can also look
forward to the product giving you long and satisfactory service.
GUARANTEE
This CLARKE product is guaranteed against faulty manufacture for a period of
12 months from the date of purchase. Please keep your receipt as proof of
purchase.
This guarantee is invalid if the product is found to have been abused or
tampered with in any way, or not used for the purpose for which it was
intended.
Faulty goods should be returned to their place of purchase, no product can
be returned to us without prior permission. This guarantee does not effect your
statutory rights.
SAFETY PRECAUTIONS
• Before use, always ensure the workpiece is firmly secure and stable.
• Do not allow any person who is inexperienced in the use of hydraulic presses,
to use the press unless they are under direct supervision.
• Do not allow anyone to work directly in front of the press when it is in use.
• When using accessories such as arbor plates, be certain they are centered
below the ram and are in full contact with the bed.
• Parts being pressed may splinter, shatter, or be ejected from the press. Due to
varied applications, it is your responsibility to always use adequate guards,
wear eye protection and protective clothing when operating this press.
• Keep hands and fingers away from parts that may pinch and shift.
• Always apply the load under the centre of the ram. Offset loads can
damage the ram or ram mount and may cause the workpiece to eject.
• Failure to heed these warnings may result in damage to the equipment or
failure resulting in damage to property or personnal injury.
• Do not exceed the rated capacity of the press.

3
Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [email protected]
CONTENTS
The kit includes 15mm, 25mm , 40mm
and 50mm mandrels together with a
mandrel adaptor, pressing plate and
a mandrel storage bracket.
MOUNTING THE BRACKET
Bolt the mandrel storage bracket to
the side of the press frame as shown.
FITTING THE MANDRELS
Any of the mandrels provided may
be connected to the end of the ram
using the adaptor supplied.
Alternatively, the basic ram pressure
cap supplied with the press can be
fitted as shown. Secure the pressure
cap by tightening the grub screw
with a suitable hexagonal key.
If one of the mandrels is required, the
adaptor must be fitted instead of the
pressure cap. Secure the adaptor by
tightening the grub screw with a
hexagonal key.
Select your mandrel depending
upon the size of the workpiece
bearing surface.
The mandrel can then be pushed
into the adaptor where the built-in
spring clip will hold it in place.
Store the mandrels in their positions
on the mounting bracket when not in
use.