CLOAKROOM SOLUTIONS GSRN20 User manual

ASSEMBLY INSTRUCTIONS
GSRN20 &GSRN30
Tel: [phone]
Email: [email protected]

1Mark drilling points
2 people are required for assembly.
Person 1 holds the cloakroom rail at the point where the cloakroom rail is to be mounted.
The wall bearings are already pre-assembled.
Person 2 marks the assemblage points on the left and on the right.
To do this, use a pen whose lines can be removed afterwards with as little effort as possible;
e.g. a pencil with a light lead.
1.1
1.2
Carefully put the cloakroom rail back down.
Find the center of the two drawn circles. After that, remove the two circles, leaving only the
center marks.
1.4
1.3

2Drill holes
Ø8 mm
min. 65 mm
3Insert dowels
2x
2x
4Dismantle the wall brackets from the cloakroom rod on both sides
4.1 4.2
Please loosen the fixing screws only slightly.
Please do not turn this off.
5Installation of the wall bearing inner sleeves
4.3 4.4
Wall bearing inner sleeve
2x
Wall Bearing Outer Sleeve

6Assembly of the wardrobe rod
6.1
Person 1 holds the cloakroom rail between the two screwed wall bearing inner sleeves.
Person 2 pushes the wall bearing outer sleeves outwards - all the way to the wall. TIP: If you
turn the outer sleeves so that the fixing screws point backwards, they will no longer be visible
from the front later.
6.2
Person 2 tightens all 4 fixing screws with the Allen key provided. Then the assembly is
complete.
6.3