Cloud PC-200 User manual
PC-200 Pendant Housings for
CS-C Series loudspeakers
Installation Guide
PC-200 Installation Guide V1.12
CAUTION – Speaker must be installed by a qualied speaker technician.
INTRODUCTION
The PC-200 is a pendant housing for Cloud CS-C Series loudspeakers types CS-C5, CS-C6, CS-C8 or CS-CSUB8. It
is available in black (PB-200B) or white (PB-200W) nish to match the speaker. CS-C Series speakers are normally
ush-tted in ceilings: using a PC-200 housing allows them to be suspended from a single point xing, either
from a ceiling or in a space without a ceiling, where a cable tray or steelwork can provide the xing.
This Installation Guide describes the assembly of the pendant housing: please also refer to the Installation Guide
supplied with the loudspeaker itself for details of power tap settings.
The table below gives weights of the PC-200 housing complete with a speaker. Installers should ensure that the
chosen xing point is sufcient to support at least twice this weight.
SPEAKER TYPE GROSS WEIGHT
CS-C5 4.5 kg
CS-C6 5.5 kg
CS-C8 5.6 kg
CS-CSUB8 7.6 kg
Dimensions
Top View
All dimensions in mm
Side View
PC-200 Installation Guide V1.1 3
Installation
Step 1
Unpack the PC-200 housing. Packed with the PC-200
you should also nd:
3 x eye bolts
3 x hanging cables (1 meter or 39.4 inches)
3 x snap type carabiner hooks
1 x screw type carabiner hook
Step 2
Fit the three eye bolts into the tapped inserts in the
top of the housing, and tighten.
Step 3
Remove the magnetic grille from the speaker. Invert
the housing and t the speaker: note that all CS Series
speakers compatible with the PC-200 have the same
outside diameter.
Tighten the four dog ear clamps to secure the speaker
in the housing, but do not over-tighten.
Step 4
Set the tap switch for the desired power setting and
attach the grille leash. See Step 4 of the CS Series
Installation Guide. Replace the grille.
Tap Switch
Grill Leash
www.cloud.co.uk www.cloudusa.pro
Step 5
Attach the three snap type carabiners to one end
of each of the hanging cables, and then attach the
carabiners to the eye bolts.
Step 6
Connect the installed speaker cable to the Euroblock
connector (supplied with the CS Series speaker).
If daisy-chaining to another speaker, connect the
“outgoing” cable to the LINK pins of the connector.
Step 7
Attach the screw type carabiner to the free ends of all
three hanging cables. The assembly is now ready for
suspension from the intended xing point.
Step 8
Plug the Euroblock connector into the socket on
the rear of the speaker, Use cable ties to secure the
cable(s) neatly to one (or two) of the hanging cables.
